Raspberry PI 2 / B + / 3 housing with a light-blue fan

Evaluation kit with Zynq Ultrascale+ MPSoC, integrating the ARM Cortex-A53 platform, Cortex-R5 real-time processor, Mali-400 MP2 graphics processor and FinnFET+ programmable logic. Provides the SYZYGY interface connector. Digilent Genesys ZU-3EG (410-383-3EG)

GPS module with GNSS L76X receiver. It can receive data from GPS, BDS and QZSS systems. It uses the UART interface and offers an accuracy of up to 2.5 m. Waveshare L76X GPS HAT

The 1.5V AAA alkaline battery allows the use of small portable electrical devices without the need for mains power. Set contains 12 pieces.  GP 24A-PB(8+4)

High purity 100% silicone oil spray protection and lubrication for versatile use. MICRO CHIP ELEKTRONIC ART. 192

Black and silver aluminum case designed for Raspberry Pi 4B. It acts as a heat sink and ensures proper heat dissipation from the processor. FLIRC 102476

Lens for ArduCAM cameras with variable M12 lens designed for Raspberry Pi. It is characterized by a 8mm focal length, 40/45 ° view angle and 1/3 format. ArduCAM LS-8020

BeagleBone AI is a minicomputer with an AM5729 processor, it has 1 GB of DDR3L RAM memory. It was created to explore issues related to artificial intelligence. BBBONE-AI

NanoPi M4V2 is a FriendlyELEC single board computer. It uses LPDDR4 RAM memory and adds among others: POWER and RECOVERY micro switches and a microphone input.

NanoPI NEO is a single-board chip from FriendlyELEC with a RAM of 256 MB, successfully competing with the systems created by the giant in this field Raspberry Pi. It is 25% smaller and cheaper than the Raspberry Pi Zero board with similar capabilities

HAT for powering over Ethernet (PoE) for Raspberry Pi. It allows you to use the PoE interface to power the minicomputer via an Ethernet cable

HAT for powering over Ethernet (PoE) for Raspberry Pi. It allows you to use the PoE interface to power the minicomputer via an Ethernet cable

The SparkFun Qwiic Shield for Arduino Nano allows you to add the SparkFun Qwiic ecosystem to development boards that use the Arduino Nano Footprint in an easy-to-assemble shield. It connects the I2C bus (GND, 3.3V, SDA, and SCL) on your Arduino Nano to four SparkFun Qwiic connectors.

The SparkFun Qwiic Shield for Thing Plus provides an easy-to-assemble way to add the SparkFun Qwiic ecosystem to any development board with the Thing Plus Footprint. It connects the I2C bus (GND, 3.3V, SDA, and SCL) on your Thing Plus to four SparkFun Qwiic connectors. Sparkfun DEV-16138

Cytron 0.8Amp 5V-26V DC Motor Driver Shield - DC motor driver for Arduino

Konwerter UART - RS232

Module with microSD card readerv