.png)
- Out-of-Stock
ST-LINK/V2 (Compatible) type A
ID: 559856
Low cost programmer for STM32 and STM8 microcontrollers fully compatible
with the ST-Link V2
Overview
A low cost programmer fully compatible with the ST-Link V2. It supports the
official ST-Link Utility software as well as popular IDEs (Keil MDK, IAR,
Atollic True Studio etc.).
Attention!
The programmer is sent random colour.
Included
- ST-Link V2 compatible programmer
- 4 cables with female connectors
559856
You might also like
Cables for evaluation boards, set of 10 pcs., blue colour
zł5.20
24h
Available quantity: 279
Available
Cables for evaluation boards, set of 10 pcs., red colour
zł5.90
24h
Available quantity: 284
Available
Cables for evaluation boards, set of 10 pcs., green colour
zł5.46
24h
Available quantity: 71
Available
ST-LINK/V2 in-circuit debugger/programmer for STM8 and STM32 microcontrollers
zł121.28
24h
Available quantity: 6
Available
ST-LINK/V2-ISOL in-circuit debugger/programmer for STM8 and STM32 microcontrollers with digital isolation, STM, RoHS
zł280.86
24h
Available quantity: 8
Available
A new programmer-debugger with the USB interface. It supports the STM32 microcontrollers via SWD interface. ZL30PRGv2-1 is compatible with the STMicroelectronics ST-Link/V2-1. It also has the function of USB-UART converter, thanks to which it can successfully replace the KAmodRS module.
zł79.00
24h
Available quantity: 148
Available
Other products in the same category (16)
Digital Proximity, Ambient Light, RGB and Gesture Sensor, Avago Technologies, RoHS
Retired
No product available!
No product available!
Integrated analogue base station RFID (front-end) of the company EM Microelectronic with a frequency of 13.56MHz. The system has a SOP20 housing
Retired
No product available!
Computer fan housing Raspberry Pi 3, Raspberry Pi 2 model B and Raspberry Pi 1 model B + in dark blue plastic color
Retired
No product available!
Case for the Raspberry PI 2 model B, Raspberry PI 1 model B+ and Raspberry PI 3 computers, manufactured from high quality acrylic. CLEAR
Retired
No product available!
No product available!
No product available!
No product available!
Infrared sensor that allows measurement of distances up to 15cm, has a built-in infrared illuminator, IR receiver and a perimeter of the received signal
Retired
No product available!
Miniature (22x13.5x6mm) WiFi module b / g / n with TCP and UDP protocols operating in standalone and access point modes. 2.0mm goldpin connector. The module is equipped with a UART interface, it is also possible to control GPIO lines (also as PWM). Powered by 3.3V. Antenna: copper wire
Retired
No product available!
Ultra miniature WiFi b/g/n module, equipped with UART, SPI, PWM and GPIO interfaces. The ability to work as an access point and in standalone mode. 3.3V power supply.HF-LPT200-1
Retired
No product available!
This transducer is about 45mm in diameter and has 4Ω impedance and should be run at about 5W
Retired
No product available!
SPIRIT1 868 MHz low power RF module with integrated microcontroller
Delivery date unknown
No product available!
Read/Write analog front end for 125 kHz RFID Basestation, SOIC16, EM Microrlectronic, RoHS
Retired
No product available!
Bitscope Micro is a miniature measuring instrument with a USB interface, it can act as an 8-channel logic analyzer (40MS / s, 3.3V or 5V) or a 2-channel oscilloscope (bandwidth up to 20MHz). In addition, Bitscope can generate a clock signal as well as sinusoidal, triangular, rectangular and saws
Retired
No product available!
High performance WLAN USB module which enables the Raspberry Pi to connect to a Wi-Fi network
Retired
No product available!
Low cost programmer for STM32 and STM8 microcontrollers fully compatible
with the ST-Link V2