- Out-of-Stock
The housing fits Arduino UNO and Arduino Leonardo . The casing consists of two plates (top and bottom) and six Arduino plate holders made of transparent plastic, the whole combines four metal bushes with screws. The upper plate has holes above the shield connectors and over the ISCP connector.
The Arduino plate visible in the pictures is not included in the kit.
Manufacturer
Responsible person
Board with Atmel ATmega328 microcontroller from the AVR family, there are 14 I / O lines, 6 PWM channels and 6 analog inputs. The additional ATmega16U4 microcontroller realizes communication via the USB interface
Arduino Uno Rev3 is a popular board with Atmel ATmega328 microcontroller from the AVR family, there are 14 I / O lines, 6 PWM channels and 6 analog inputs. The additional ATmega16U4 microcontroller realizes communication via the USB interface. Arduino A000066
Development board with ATmega32u4 microcontroller (AVR), 20 I / O lines, 7 PWM channels, 16 MHz quartz, micro-USB. Easy-to-use USB support libraries, sensors, displays, etc. are available. A000052
Integrated analogue base station RFID (front-end) of the company EM Microelectronic with a frequency of 13.56MHz. The system has a SOP20 housing
No product available!
Computer fan housing Raspberry Pi 3, Raspberry Pi 2 model B and Raspberry Pi 1 model B + in dark blue plastic color
No product available!
Case for the Raspberry PI 2 model B, Raspberry PI 1 model B+ and Raspberry PI 3 computers, manufactured from high quality acrylic. CLEAR
No product available!
No product available!
No product available!
No product available!
Infrared sensor that allows measurement of distances up to 15cm, has a built-in infrared illuminator, IR receiver and a perimeter of the received signal
No product available!
Miniature (22x13.5x6mm) WiFi module b / g / n with TCP and UDP protocols operating in standalone and access point modes. 2.0mm goldpin connector. The module is equipped with a UART interface, it is also possible to control GPIO lines (also as PWM). Powered by 3.3V. Antenna: copper wire
No product available!
Ultra miniature WiFi b/g/n module, equipped with UART, SPI, PWM and GPIO interfaces. The ability to work as an access point and in standalone mode. 3.3V power supply.HF-LPT200-1
No product available!
This transducer is about 45mm in diameter and has 4Ω impedance and should be run at about 5W
No product available!
No product available!
Read/Write analog front end for 125 kHz RFID Basestation, SOIC16, EM Microrlectronic, RoHS
No product available!
Bitscope Micro is a miniature measuring instrument with a USB interface, it can act as an 8-channel logic analyzer (40MS / s, 3.3V or 5V) or a 2-channel oscilloscope (bandwidth up to 20MHz). In addition, Bitscope can generate a clock signal as well as sinusoidal, triangular, rectangular and saws
No product available!
High performance WLAN USB module which enables the Raspberry Pi to connect to a Wi-Fi network
No product available!
32-bit microcontroller from the STM32F4 family with ARM Cortex-M4 core, 256kB Flash, 128KB SRAM, I2C, HDMI-CEC, Irda, LIN, SPI, UART / USART, USB, DMA, PWM, 1.7 ... 3.6V, 64-LQFP
No product available!
32-bit microcontroller from the STM32F4 family with ARM Cortex-M4 core, 512kB Flash, 128KB SRAM, I2C, HDMI-CEC, Irda, LIN, SPI, UART / USART, USB, DMA, PWM, 1.7 ... 3.6V, 64-LQFP
No product available!
Transparent housing for Arduino UNO and Leonardo, open from the sides, upper plate with holes for shield connectors and ICSP connector