- Out-of-Stock
Patchcord UTP 5E Ethernet cable with a length of 2 m - gray, with 2xRJ45 connectors
The cable is designed for connections at distribution points and subscriber outlet connections to active devices such as a switch, router or directly to the computer's network card. Patchcords are used in connections of passive and active devices in LAN, Ethernet, xDSL and telephone networks - at home, office and industry. Made in accordance with the applicable standards, subjected to repeated tests and verification ensure the highest transmission parameters and compliance with the given category.
They meet the following product and application standards: PN-EN 41003: 2001, PN-EN 50173: 2004, ISO / IEC 11801: 2002, ANSI / TIA / EIA-568-B.2-1, PN-EN 60-603-7 -1: 2002 (U).
Data sheet
Tester for testing cables with RJ45 and RJ11 plugs. Detects abnormalities such as short circuits, openings, reversed wires, swapped pairs. NAR0167
Crimping tool for 8P8C (RJ-45), 6P6C (RJ-12), 6P4C (RJ-11), 6P2C plugs with a clipper. NAR0008
Connector pliers for 8-pin, 6-pin, 4-pin connectors, incl. 8P8C (RJ-45), 6P6C (RJ-12), 6P4C (RJ-11), 4P4C, 4P2C PLUGS, DEC / OFF SET PLUG-6P6C, equipped with 2 knives. NAR0051
No product available!
hb03w-p-000-00
No product available!
No product available!
No product available!
Adafruit 2486 - NETduino 3 WiFi is an open source electronics platform using the .NET Micro Framework
No product available!
The Arduino M0 represents a simple, yet powerful, 32-bit extension of the Arduino UNO platform. The board is powered by Atmel’s SAMD21 MCU, featuring a 32-bit ARM Cortex® M0 core.
No product available!
Arduino Yun Mini is a breadboard PCB developed with ATmega 32u4 MCU and QCA MIPS 24K SoC CPU operating up to 400 MHz. Qualcomm Atheros CPU supports a Linux distribution based on OpenWRT named Linino. The board has built- in WiFi, supports 20 digital input/output pins, a 16 MHz crystal oscillator, a micro USB connector, an ICSP header, two reset buttons and one user button.
No product available!
The Arduino 4 Relays Shield allows your Arduino driving high power loads that cannot be controlled directly by Arduino\'s digital pins. The Shield features four relays, each relay with 2 pole changeover contacts (NO and NC). Four LEDs indicate the on/off state of each relay. (A000110)
No product available!
The Arduino Ethernet Shield 2 allows an Arduino Board to connect to the internet. It is based on the Wiznet W5500 Ethernet chip. The Wiznet W5500 provides a network (IP) stack capable of both TCP and UDP. There is an onboard micro-SD card slot, which can be used to store files for serving over the network. It is compatible with the Arduino Uno and Mega
No product available!
The Leonardo ETH is a microcontroller board based on the ATmega32U4 and the new W5500 TCP/IP Embedded Ethernet Controller (datasheet).
No product available!
The Arduino 9 Axes Motion Shield allows your Arduino to measure movement: orientation, acceleration and magnetic field. A000070
No product available!
The Arduino GSM Shield connects your Arduino to the internet using the GPRS wireless network. Just plug this module onto your Arduino board, plug in a SIM card from an operator offering GPRS coverage and follow a few simple instructions. You can also make/receive voice calls (you will need an external speaker and microphone circuit) and send/receive SMS messages.
No product available!
The Arduino GSM Shield connects your Arduino to the internet using the GPRS wireless network. Just plug this module onto your Arduino board, plug in a SIM card from an operator offering GPRS coverage and follow a few simple instructions. You can also make/receive voice calls (you will need an external speaker and microphone circuit) and send/receive SMS messages.
No product available!
Plastic holder that could fit all the boards with Arduino UNO size (68,6 mm x 53,4 mm). Contains 5 pieces in different colours. A000018
No product available!
CryptoShield is a dedicated security peripheral for the Arduino. This shield adds specialized ICs that perform various cryptographic operations which will allow you to add a hardware security layer to your Arduino project. It also is a nice device for those performing embedded security research. DEV-13183
No product available!
No product available!
Banana Pi R1 acrylic clear case. The case needs to be assembled by yourself
No product available!
Patchcord UTP 5E Ethernet cable with a length of 2 m - gray, with 2xRJ45 connectors