- Out-of-Stock
New products
New products New products
zł119.00
Delivery date unknown
zł119.00
Delivery date unknown
AVT1969 A + - night lamp driver with time system. PCB and programmed layout
ID: 566133
Printed circuit board with programmed night lamp controller system with time system. AVT1969 A +
Description
The proposed controller is a time system that when connected to a light source acts as a night light.
It is best suited for supplying 12 V LED strips and some LED bulbs working in diode configuration with a series resistor. Each time the button is pressed, the timer will start, which will smoothly turn on the light source connected to the output of the system. After the specified time, set with the potentiometer PR1, the light goes out slowly.
Project AVT 1969 EP 08/17
properties
- The dimensions of the plate 49x33mm
Included
- PCB board and programmed layout
566133
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Other products in the same category (16)
2in1 soldering station with hot air soldering iron and soldering tip. 700 W power station. Equipped with LCD display, button operated. YIHUA 992D
Retired
No product available!
16-Conductor Ribbon Cable with IDC Connectors 20"
Retired
No product available!
SBC6000X Single Board Computer, AT91SAM9261
Delivery date unknown
No product available!
No product available!
Ethyl alcohol 96%, fully denatured and supplied in a 5L canister, is a highly effective cleaner and degreaser, ideal for use in electronics, due to its rapid evaporation and no traces left on the cleaned components
Retired
No product available!
PCB for remote two-channel PILOT switch. AVT5422 / 1 A
Retired
No product available!
No product available!
No product available!
Simulation set for Siemens S7-1200 PLC devices. Using this set, it is possible to verify the operation of a program written for a PLC by applying the appropriate states to the digital inputs, to the analogue (ADC) inputs voltages from the built-in or external sensors. LED status monitoring is possible.
Retired
No product available!
No product available!
No product available!
collective work, R. Piramidowicz (ed.), RS Romaniuk (ed.)
Delivery date unknown
No product available!
No product available!
No product available!
A highly cost-effective audio hat which fits on the GPIO of the Raspberry Pi B+/2B/3B, uses i2S interface audio solution, supports 24-bit /192KHz high quality sound, compatible with other audio equipment via RCA lotus socket, includes a built-in high fidelity headphone amplifier, where you can plug in a 3.5mm audio jack directly. DFR0449
Retired
No product available!
Wires with Pre-crimped Terminals 10-Piece Rainbow Assortment M-F 60"
Retired
No product available!
Printed circuit board with programmed night lamp controller system with time system. AVT1969 A +