- Out-of-Stock
AVT5599 B - remotely controlled 4-channel switch. Self-assembly set
ID: 566273
AVT kit for self-assembly of a remotely controlled 4-channel switch. AVT5599 B
Description
The device enables remote switching on / off of four devices with the use of typical infrared remote controls from general-purpose equipment. Its undoubted advantage is the possibility of cooperation with practically any infrared remote control, and the procedure of learning the pilot codes comes down to a few easy steps.
Project AVT 5599 EP 08/17
properties
- ATmega8 microcontroller
- 230 V AC power supply
- Independent switching on / off of 4 relays by means of an infrared transmitter from RTV equipment
- A printed circuit board matched to the Z4 housing
- The dimensions of the tile 74 x 145mm
Included
- Set of parts for mounting the switch
566273
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Other products in the same category (16)
No product available!
Wires with Pre-crimped Terminals 20-Piece Rainbow Assortment F-F 36"
Retired
No product available!
No product available!
No product available!
No product available!
Pre-assembled precision timer 1 second-99 minutes. AVT1995 C
Retired
No product available!
No product available!
The eXtremestyle silicone cable (1.5m length) with Lightning connector. Allows you to charge the device and transfer data. eXtreme S15ULW
Retired
No product available!
AI module with RISC-V Kendryte K210 chip, which can work with micro: bit, Arduino and Raspberry Pi. Equipped with a camera, microphone, speaker, IPS screen and Wi-Fi communication. Seeed Studio 101990646
Retired
No product available!
No product available!
KA-NUCLEO-F411CE is a development board equipped with standard Arduino UNO connectors. Board is based on microcontroller STM32F411CE. The embedded programmer (compatible with ST-Link/V2-1) makes possible programming and debugging of microcontroller via USB connector.
Retired
No product available!
No product available!
No product available!
AVT self-assembly kit PAmp_LM4766, 2 x 20W audio power amplifier 8om. AVT1833 B
Retired
No product available!
Spring dedicated to the heating table of 3D printers. It allows you to adjust the degree of tightening the knob, and thus enables the proper leveling of the working table
Retired
No product available!
Circuit construction and testing kit using Analog Discovery 2 and LabVIEW. Digilent 471-018
Retired
No product available!
AVT kit for self-assembly of a remotely controlled 4-channel switch. AVT5599 B