- Out-of-Stock
Heat-shrinkable tubes with very good mechanical and electrical parameters and a low shrink temperature, thanks to which the installation process is fast and accurate. Their primary applications are electrical insulation, mechanical protection and wire connection identification.
Manufacturer
Responsible person
A set of 100 pieces of various colored heat-shrinkable tubing for wire insulation, 10 cm long. NAR0832
A set of 328 colored heat shrink tubes with a diameter of 1, 2, 3, 4, 6, 8, 10 and 14 mm and a length of 40 or 80 mm.
No product available!
Banana Pi R1 acrylic clear case. The case needs to be assembled by yourself
No product available!
The housing for the Banner PI G1 Debugger made of transparent plastic. Housing for self-assembly
No product available!
The I2C electric level conversion module is specifically designed for Banana Pi. The module converts the 3.3V of I2C electric level to 5V level or converts 5V to 3.3V
No product available!
BPI AD/DA extend module with the PCF8591 single-chip, single-supply low-power 8-bit CMOS data acquisition device with four analog inputs, one analog output and a serial I2C-bus interface
No product available!
No product available!
5dB antenna for the Banana Pi R1 router in the version with 300Mps wifi and five LAN 100/1000 ports.
No product available!
STM32F103 programming cable for Open Debugger Burn Board and Banana Pi G1 connection
No product available!
CC3200 programming cable for Open Debugger Burn Board and Banana Pi G1 connection
No product available!
CC2530 and CC2540 programming cable for Open Debugger Burn Board and Banana Pi G1 connection
No product available!
It is a standard audio-video cable, which can be successfully used to connect Banana Pi M1 or Raspberry Pi 1 model B and A. Cable length is 98 cm, has two ends of the chinch type.
No product available!
COM-11964 Button a white economy grade 100mm diameter (outside diameter) dome illuminated push button comes with an LED, securing nut and a long life horizontal microswitch.
No product available!
Cobbler Plus - adapter enabling connection of GPIO Raspberry Pi A +, B + and Pi 2 lines to the contact plate (2.54 mm). The version is assembled. Adafruit 2029
No product available!
T-Cobbler Plus - adapter enabling connection of GPIO Raspberry Pi A +, B + and Pi 2 lines to the contact plate (2.54 mm). Goldpin connectors are included, for self-assembly. Adafruit 1989
No product available!
FPC tape length 250 mm, 50 lines, pitch 0.5 mm. Adafruit 1682
No product available!
μHex is the first low-power controller which is compatible with Arduino. It is very suitable for the battery power supply environment. A 210mAh CR2032 cell battery could make it work 60 days long. DFR0343
No product available!
Complete Robot Kit with Romeo V2 All-in-one controller, Sharp GP2Y0A21 Distance Sensor, 9g micro servo which allow you to install sensors, servos and even do some prototypings. KIT0071
No product available!
Heat shrink tube for electrical and mechanical insulation, diameter before shrinking 8 mm; diameter after shrinking 4 mm, set of 10 pieces, 1 meter long