Rectangular neodymium magnet 10x4x2mm

Male terminal block, angled, 5-pin. Pitch 5.0mm. Height 7.8mm. 2EDGRC-5.0-5P

PRT-12839 Arduino Uno Enclosure - Black Plastic

Simulation set for Siemens S7-1200 PLC devices. Using this set, it is possible to verify the operation of a program written for a PLC by applying the appropriate states to the digital inputs, to the analogue (ADC) inputs voltages from the built-in or external sensors. LED status monitoring is possible.

High-power brushed DC motor, 120:1 reduction gearbox, intended for operation at 4.5 V, 9.7mm-long gearbox, 3 mm-diameter D-shaped output shaft that is offset from but parallel to the motor shaft, built-in safety clutch. Pololu 1512

ARK terminal connector spring 12-pin, pitch 2.5 mm, non-detachable.

Module with a 3-axis gyroscope (ITG 3200 system). The measuring range is ± 2000 ° / s. The I2C interface is used for communication. The module has a low power consumption (typically 6.5 mA). The module has a connector in accordance with the Grove standard. Seeed studio 101020050

Printed circuit board and programmed system for the electromagnetic transom control. AVT1919 A +

POWER SUPPLY 4W - MINILAMPER - PLATE

Case for the Raspberry PI 2 model B, Raspberry PI 1 model B+ and Raspberry PI 3 computers, manufactured from high quality acrylic. CLEAR

Development board with ATmega328P microcontroller equipped with 14 I/O lines, 6 PWM channels, 6 analog inputs and FT231X chip. Compatible with Arduino UNO Rev3. Cytron CT-SE

UNUSUAL DIGITAL OSCILLOSCOPE - PROGRAMMED SYSTEM

Following the modern trend of minimalistic and functional design, Ugears is proud to present a new clever and practical addition to their collection of wooden mechanical models, the Foldable Phone Holder of the Mini-series.

Clean lines and functionality coupled with Ugears iconic design was the main ground on which the idea of the foldable phone stand was born and developed. UGears 70145

Development kit based on MediaTek MT7622 chip with 64-bit ARM Cortex-A53 dual-core processor. It is equipped with 1GB SDRAM, 8GB eMMC memory and numerous connectors and interfaces such as SATA, Ethernet, microSD socket and USB 3.0 Host. The kit creates a router that can run on various open source operating systems, including OpenWrt and Linux. Banana Pi BPI-R64

COMMUNICATION TRACK PLC - PRINTED PLATE