- Out-of-Stock
Tadeusz Mikulczyński
The work contains 17 instructions for laboratory exercises from the basics of automation and automation of technological processes.
The topics of the exercises include issues found in basic mechanical technologies: machining, machining, founding, welding and assembly.
Table of Contents
Preface
1. Static characteristics of automation elements
2. Dynamic characteristics - time
3. Dynamic characteristics - frequency
4. Examination of elements of automatic control systems
5. Intelligent measuring transducers in automation systems
6. Simulation tests of automation elements in the Matlab-Simulink environment
7. Two-state regulation
8. Three-position regulation
9. PLC programming languages
10. Mathematical basis of digital automation systems
11. Contact and relay elements and systems
12. Synthesis of combinational control systems
13. Synthesis of sequential control systems
14. Modeling and programming of sequential processes
15. Modeling and programming of concurrent processes
16. Modeling and programming of complex processes
17. Industrial communication networks (Fieldbus).
A single comparator with a fast response time between the rails in the SOT23-5 housing. STMicroelectronics TS3011ILT
No product available!
Precision amplifier designed to measure the current on the shunt resistor in the SOT23-5 housing. STMicroelectronics TSC101AIYLT
No product available!
A double operational amplifier with a large bandwidth in the MiniSO-8 housing. STMicroelectronics TSV912AIYST
No product available!
TSV612IST, Rail to rail input/output 5V CMOS Op-Amps, micro-power (10uA), GBP=120kHz, dual, Mini SO8
No product available!
No product available!
TSV631ILT, Rail-to-rail input/output, 60 µA, 880 kHz, 5 V CMOS operational amplifiers, SOT-23-5
No product available!
No product available!
A small single board computer with a Sitara ™ processor (1 GHz, ARM Cortex-A8), 512 MB DDR3 RAM. It has a built-in 3D accelerator. The board also includes a microSD card slot and a microUSB slot.
No product available!
TSZ182IYST, Very high accuracy (25 µV) high bandwidth (3 MHz) zero drift 5 V operational amplifiers, Mini SO8
No product available!
Raspberry Pi Compute Module 3+ (CM3 +) is a SoM module containing key elements of the Raspberry Pi 3 A + / B + computer, including Broadcom BCM2837B0 processor, 1 GB RAM, 8 GB eMMC memory. The module is equipped with a 200-pin SODIMM connector.
No product available!
Orange Pi 3 1GB is a mini-computer equipped with SoC Allwinner H6 (quad-core, frequency up to 1.8 GHz, 64-bit architecture, ARM Cortex ™ -A53 core). It has 1GB RAM (LPDDR3), Mali T720 graphics. On the board you can run Android 7.0 and Linux (Ubuntu, Debian).
No product available!
Orange Pi 3 2GB is a mini-computer equipped with SoC Allwinner H6 (quad core, frequency up to 1.8 GHz, 64-bit architecture, ARM Cortex ™ -A53 core). It has 2GB RAM (LPDDR3), Mali T720 graphics. On the board you can run Android 7.0 and Linux (Ubuntu, Debian).
No product available!
A small evaluation board with the nRF52840 (ARM Cortex-M4) system designed for projects related to Mesh networks. Adafruit 3999
No product available!
Orange Pi 3 1GB is a mini-computer equipped with SoC Allwinner H6 (quad-core, frequency up to 1.8 GHz, 64-bit architecture, ARM Cortex ™ -A53 core). It has 1GB RAM (LPDDR3), Mali T720 graphics chip, 8GB eMMC memory. The board can run Android 7.0 and Linux.
No product available!
Orange Pi 3 2GB for minicomputer equipped with SoC Allwinner H6 (quad-core, frequency up to 1.8 GHz, 64-bit architecture, ARM Cortex ™ -A53 core). It has 2 GB of RAM (LPDDR3), a Mali T720 graphics chip, 8 GB of eMMC memory. The board can run Android 7.0 and Linux.
No product available!
Module with a UV ultraviolet light sensor VEML6075. Enables measurement of the level of UVA (320-400nm) and UVB (280-320nm) radiation. It communicates via the I2C bus. SparkFun SEN-15089
No product available!
Tadeusz Mikulczyński