Step-Down Buck Voltage Regulator 12V 300mA D24V3F12
ID: 210631
zł28.86
Tax included
zł23.46 tax excl.
The Step-Down D24V3F12 Buck Voltage Regulator module gives the output voltage of 12V with a wide input voltage range of 14.5-42V and a maximum output current of 300 mA. Pololu 2100
Description
The Step-Down D24V3F12 buck voltage regulator module has a 12 V output voltage with a wide input voltage range of 14.5-42V. The maximum current load of the module is 300 mA. The converter achieves a standard efficiency of 80 - 90% at similar values of input and output voltage.
Note! The board does not have reverse-voltage protection. Incorrect power connection will cause permanent damage of the module.
The inverter module is also available in other voltage variants with constant output voltage: 3.3 V , 5 V and 9 V.
Features
- Input voltage: 14.5-42 V
- 12 V output voltage with 4% accuracy
- Type. maximum current: 300 mA
- Built-in protection against short-circuit and overheating
- Type. efficiency: 80..90%
- Size: 13 × 10 × 3 mm
- Possibility of mounting goldpin
Connections
- VIN - power input (14.5-42V)
- GND - mass
- VOUT - output
- SHDN – Shutdown pin can be driven low (under 0.3 V) to turn off the output and put the board into a low-power state that typically draws 20 μA, and it can be driven high (above 2.3 V) to enable the board. If you do not need to use the shutdown feature, the SHDN pin can be directly connected to VIN to permanently enable the board. You should not leave this pin disconnected as this can result in unpredictable behavior.
Kit contains
- Buck converter module D24V3F12 x1
- Goldpin connector 4pin straight x1
- Goldpin connector 4pin right-angle x1
210631
Data sheet
- Output voltage
- 12V
- Output current
- 300 mA
- Converter type
- Step-down
- Supply voltage min
- 14,5 V
- Supply voltages max
- 42 V
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Other products in the same category (16)
Step Down DC-DC converter module based on LM2596 circuit, input voltage 3-40V, regulated output voltage 1.5--35V
zł3.92
24h
Available quantity: 1439
Available
No product available!
Step-Down converter D36V50F9 with an output voltage of 9 V, an input voltage from 9.9 to 50 V and a maximum output current of 7 A. Pololu 4094
zł156.87
24h
Available quantity: 1
Available
This small synchronous switching step-down (or buck) regulator takes an input voltage of up to 38 V and efficiently reduces it to 9 V. The board measures only 0.7″ × 0.7″, but it allows a typical continuous output current of up to 2.5 A. Typical efficiencies of 85% to 95% make this regulator well suited for powering moderate loads like sensors or small motors.
zł86.59
4 weeks
No product available!
This compact (0.4″ × 0.5″) switching step-down (or buck) voltage regulator takes input voltages up to 50 V and efficiently reduces them to 7.5 V while allowing for a maximum output current of 600 mA. It has a very low dropout, so it can be used with input voltages that are within a few hundred millivolts of its output.
zł26.40
24h
Available quantity: 1
Available
Step-Down converter with adjustable output voltage from 1.25 to 36 V, input voltage from 4 to 38 V and maximum current up to 5 A. Board equipped with a voltmeter with display
zł18.56
24h
Available quantity: 5
Available
The Step-Down D24V6F5 Buck Voltage Regulator module gives the output voltage of 5V with a wide input voltage range of 7-42V and a maximum output current of 600 mA. Pololu 2107
zł41.72
24h
Available quantity: 1
Available
Step-Down Voltage Regulator D24V25F5. Pololu 2850
zł82.64
24h
Available quantity: 2
Available
This small synchronous switching step-down (or buck) regulator takes an input voltage of up to 38 V and efficiently reduces it to 7.5 V. The board measures only 0.7″ × 0.7″, but it allows a typical continuous output current of up to 2.5 A. Typical efficiencies of 85% to 95% make this regulator well suited for powering moderate loads like sensors or small motors.
zł91.16
24h
Available quantity: 2
Available
The Step-Down D24V6AHV Buck Voltage Regulator module with adjustable output voltage in the range of 4-25V with a wide input voltage range of 4.5-42V and a maximum output current of 600 mA. Pololu 2104
zł37.77
24h
Available quantity: 2
Available
Step-Down converter D36V50F7 with an output voltage of 7.5 V, an input voltage from 8.3 to 50 V and a maximum output current of 7 A. Pololu 4093
zł155.25
24h
Available quantity: 2
Available
Step-Down DC-DC converter module based on the D36V6F5 chip. Input voltage 5.2..50V, output voltage 5V (max. 600mA). Pololu 3792
zł22.63
4 weeks
No product available!
The Step-Down D24V3F5 Buck Voltage Regulator module gives the output voltage of 5V with a wide input voltage range of 7-42V and a maximum output current of 300 mA. Pololu 2098
zł34.17
24h
Available quantity: 4
Available
Step-Down converter D36V28F3 with an output voltage of 3.3 V, an input voltage from 4.5 to 50 V and a maximum output current of 4.5 A. Pololu 3781
zł83.26
24h
Available quantity: 1
Available
Efficient step-down converter that reduces the input voltage from up to 45 V to a regulated output voltage range from 1.4 to 7 V, offering high efficiency and a maximum continuous current of 3.8 A. It has built-in protection against reverse polarity, overload and short circuit, and the spread spectrum function reduces EMI interference. The module is equipped with an additional potentiometer for adjusting the cut-off voltage. Pololu 4852
zł126.22
24h
Available quantity: 5
Available
VRM: Voltage Regulator Module (Rev. B) is a step-down converter based on the Texas Instruments TPS54620 chipset. Input voltage in the range 5 ... 15 V, output voltage 3.3 V or 5 V. Digilent 210-156
zł99.70
3 weeks
No product available!
The Step-Down D24V3F12 Buck Voltage Regulator module gives the output voltage of 12V with a wide input voltage range of 14.5-42V and a maximum output current of 300 mA. Pololu 2100