Step-Down Buck Voltage Regulator 9V 300mA D24V3F9
ID: 210632
zł34.77
Tax included
zł28.27 tax excl.
The Step-Down D24V3F9 Buck Voltage Regulator module gives the output voltage of 9V with a wide input voltage range of 11-42V and a maximum output current of 300 mA. Pololu 2099
Description
The Step-Down D24V3F9 buck voltage regulator module has a 9 V output voltage with a wide input voltage range of 11-42V. The maximum current load of the module is 300 mA. The converter achieves a standard efficiency of 80 - 90% at similar values of input and output voltage.
Note! The board does not have reverse-voltage protection. Incorrect power connection will cause permanent damage of the module.
The inverter module is also available in other voltage variants with constant output voltage: 3.3 V , 5 V and 12 V.
Features
- Input voltage: 11-42 V
- 9 V output voltage with 4% accuracy
- Type. maximum current: 300 mA
- Built-in protection against short-circuit and overheating
- Type. efficiency: 80..90%
- Size: 13 × 10 × 3 mm
- Possibility of mounting goldpin
Connections
- VIN - power input (11-42V)
- GND - mass
- VOUT - output
- SHDN – Shutdown pin can be driven low (under 0.3 V) to turn off the output and put the board into a low-power state that typically draws 20 μA, and it can be driven high (above 2.3 V) to enable the board. If you do not need to use the shutdown feature, the SHDN pin can be directly connected to VIN to permanently enable the board. You should not leave this pin disconnected as this can result in unpredictable behavior.
Kit contains
- Buck converter module D24V3F9 x1
- Goldpin connector 4pin straight x1
- Goldpin connector 4pin right-angle x1
210632
Data sheet
- Output voltage
- 9 V
- Output current
- 300 mA
- Converter type
- Step-down
- Supply voltage min
- 11 V
- Supply voltages max
- 42 V
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Other products in the same category (16)
Step-Down DC-DC converter module based on the D36V6F12 system. Input voltage 12.2.50V, output voltage 12V (max. 600mA). Pololu 3796
zł21.44
24h
Available quantity: 2
Available
An efficient step-down converter that reduces the input voltage to 3.3 V at a maximum current of 100 mA, offering high efficiency thanks to its low quiescent current (<20 μA). It supports input voltages from 3.3 V to 65 V, has short circuit and overheating protection, making it a reliable and energy-efficient solution. Pololu 5362
zł23.43
4 weeks
No product available!
This synchronous switching step-down (or buck) regulator takes an input voltage of up to 40 V and efficiently reduces it to 6 V with an available output current of around 15 A. Pololu 2882
zł466.10
4 weeks
No product available!
The Step-Down D24V3AHV Buck Voltage Regulator module with adjustable output voltage in the range of 4-25V with a wide input voltage range of 4.5-42V and a maximum output current of 300 mA. Pololu 2102
zł30.65
24h
Available quantity: 1
Available
An efficient step-down converter that reduces the input voltage to 5 V at a maximum current of 100 mA, offering high efficiency due to low quiescent current (<20 μA). It supports input voltages from 5 V to 65 V, has short circuit and overheating protection, making it a reliable and energy-efficient solution. Pololu 5363
zł23.43
4 weeks
No product available!
An efficient step-down converter that steps down the input voltage from as low as 45 V to a regulated output voltage range of 1.4 to 7 V, offering high efficiency and a maximum continuous current of 3.8 A. It has built-in reverse polarity, overload and short circuit protection, and the spread spectrum function reduces EMI interference. Pololu 4853
zł109.36
24h
Available quantity: 5
Available
An efficient step-down converter that reduces the input voltage to 3.3 V at a maximum current of 100 mA, offering high efficiency due to low quiescent current (<20 μA). It supports input voltages from 3.3 V to 65 V, has a Power Good (PGOOD) function, an EN input for system shutdown, and short circuit and overheat protection, making it a reliable and energy-efficient solution. Pololu 5372
zł23.43
4 weeks
No product available!
This small synchronous switching step-down (or buck) regulator takes an input voltage of up to 38 V and efficiently reduces it to 7.5 V. The board measures only 0.7″ × 0.7″, but it allows a typical continuous output current of up to 2.5 A. Typical efficiencies of 85% to 95% make this regulator well suited for powering moderate loads like sensors or small motors.
zł91.16
24h
Available quantity: 2
Available
Step-Down DC-DC converter module based on the D24V150F12 chip. Input voltage 14.5 ... 40V, output voltage 12V (max 15A). Pololu 2885
zł469.56
24h
Available quantity: 1
Available
The very small step-down 6 V, 2.5 A synchronous inverter can be supplied with voltage up to 36 V, dimensions: 17.8 mm x 17.8 mm. Pololu 2859
zł87.23
4 weeks
No product available!
The Step-Down D24V6F3 Buck Voltage Regulator module gives the output voltage of 3.3V with a wide input voltage range of 4.8-42V and a maximum output current of 600 mA. Pololu 2106
zł41.55
24h
Available quantity: 2
Available
The Step-Down D24V3F3 Buck Voltage Regulator module gives the output voltage of 3,3V with a wide input voltage range of 4.3-42V and a maximum output current of 300 mA. Pololu 2097
zł33.53
24h
Available quantity: 1
Available
The Step-Up Buck Voltage Regulator module with output voltage of 3.3V and input voltage range of 1-3V and a maximum output current of 200 mA. STMicroelectronics EVAL4971
zł69.50
24h
Available quantity: 1
Available
This small synchronous switching step-down (or buck) regulator takes an input voltage of up to 38 V and efficiently reduces it to 5 V. The board measures only 0.7″ × 0.8″, but it allows a typical continuous output current of up to 5 A. Typical efficiencies of 85% to 95% make this regulator well suited for high-power applications like powering motors or servos.
zł116.75
24h
Available quantity: 4
Available
Step-Down converter D36V50F5 with an output voltage of 5 V, an input voltage from 5.5 to 50 V and a maximum output current of 8 A. Pololu 4091
zł151.14
24h
Available quantity: 2
Available
Step-down DC-DC converter module that converts a 12 V or 11.1 V output voltage (e.g. from a lithium battery) to a voltage in the range of 1.8 V to 5.1 V. It has a power output of up to 60 W, and with an output current of up to 18 A, the module can be used to power a 5 m WS2812 RGB LED strip. DFRobot DFR1025
zł43.96
24h
Available quantity: 6
Available
The Step-Down D24V3F9 Buck Voltage Regulator module gives the output voltage of 9V with a wide input voltage range of 11-42V and a maximum output current of 300 mA. Pololu 2099