New products
New products New products
zł119.00
Delivery date unknown
zł119.00
Delivery date unknown
DC-DC Converter module Step-Down 4-50V - 3.3V D36V6F3
ID: 572719
5906623479146
zł21.18
Tax included
zł17.22 tax excl.
Step-Down DC-DC converter module based on the D36V6F3 system. Input voltage 4 ... 50V, output voltage 3.3V (max. 600mA). Polol 3791
Description
Step-Down DC / DC converter (D36V6F3 system) which reduces the input voltage (4-50 V) to 3.3 V. The maximum current capacity of the inverter module is 600 mA, it is the maximum continuous current that can be taken from the inverter. The efficiency of the converter ranges from 80 to 90%, which makes it a much better solution than linear voltage stabilizers. The inverter has protection against short-circuiting output and temperature protection. The inverter module has an additional pin allowing to turn off the inverter output. Due to its small size, it will be used in any project requiring stable power supply.
Attention!
In the case of an input voltage exceeding 28 V, the manufacturer recommends placing an additional electrolytic capacitor (at least 33uF) between the VIN and GND pins.
properties
- Based on the D36V6F3 chip
- Input voltage: 4-50 V
- Output voltage: 3.3 V
- Maximum continuous current consumed: 600 mA
- High efficiency: 80-90%
- Built-in security:
- before shorting the output
- temperature protection
- Switching frequency 2.1 MHz
- Low quiescent current: <0.1 mA
- Dimensions: 13 x 10 x 3 mm
- Weight: 0.5 g
Included
- D36V6F3 inverter module
- Straight 4 pin male connector
- Male connector, angled 4 pin
572719
Data sheet
- Output voltage
- 3,3 V
- Output current
- 0.6A
- Converter type
- Step-down
- Supply voltage min
- 4 V
- Supply voltages max
- 50 V
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
You might also like
Przetwornica DC-DC Step Down (MP1584), Uwe 4.5..28V, Uwy regulowane 0.8..20V, RoHS
zł4.77
24h
Available quantity: 56
Available
The Step Down DC-DC converter module (MP2307) allows to obtain 0.93..18V output voltage at 4.75..24V input voltage. The output voltage is regulated by a potentiometer
zł8.18
24h
Available quantity: 2
Available
Step Down DC-DC converter module based on LM2596 circuit, input voltage 3-40V, regulated output voltage 1.5--35V
zł3.65
24h
Available quantity: 798
Available
Pololu 2830
zł43.01
24h
Available quantity: 3
Available
Available
Other products in the same category (16)
This small synchronous switching step-down (or buck) regulator takes an input voltage of up to 38 V and efficiently reduces it to 7.5 V. The board measures only 0.7″ × 0.7″, but it allows a typical continuous output current of up to 2.5 A. Typical efficiencies of 85% to 95% make this regulator well suited for powering moderate loads like sensors or small motors.
zł91.16
24h
Available quantity: 2
Available
Step-Down DC-DC converter module based on the D36V6F6 chip. Input voltage 6.2..50V, output voltage 6V (max. 600mA). Pololu 3793
zł22.29
24h
Available quantity: 2
Available
The very small step-down 6 V, 2.5 A synchronous inverter can be supplied with voltage up to 36 V, dimensions: 17.8 mm x 17.8 mm. Pololu 2859
zł87.23
4 weeks
No product available!
Step-Down converter D36V50F9 with an output voltage of 9 V, an input voltage from 9.9 to 50 V and a maximum output current of 7 A. Pololu 4094
zł156.87
4 weeks
No product available!
Step Down DC-DC converter module based on LM2596 circuit, input voltage 3-40V, regulated output voltage 1.5--35V
zł3.65
24h
Available quantity: 798
Available
The Step-Down D24V6F9 Buck Voltage Regulator module gives the output voltage of 9V with a wide input voltage range of 11.5-42V and a maximum output current of 600 mA. Pololu 2108
zł32.61
4 weeks
No product available!
This small synchronous switching step-down (or buck) regulator takes an input voltage of up to 38 V and efficiently reduces it to 3.3 V. The board measures only 0.7″ × 0.7″, but it allows a typical continuous output current of up to 2.5 A. Typical efficiencies of 80% to 95% make this regulator well suited for powering moderate loads like sensors or small motors.
zł101.88
4 weeks
No product available!
This compact (0.4″ × 0.5″) switching step-down (or buck) voltage regulator takes input voltages up to 50 V and efficiently reduces them to 7.5 V while allowing for a maximum output current of 600 mA. It has a very low dropout, so it can be used with input voltages that are within a few hundred millivolts of its output.
zł25.88
24h
Available quantity: 2
Available
This small synchronous switching step-down (or buck) regulator takes an input voltage of up to 36 V and efficiently reduces it to 7.5 V. The board measures only 0.7″ × 0.7″ yet delivers a typical continuous output current of up to 2.4 A and features reverse voltage protection.
zł87.23
4 weeks
No product available!
Step Down converter module with an output voltage of 5 V and a maximum current of 2x2,5 A. The board is equipped with four USB connectors
zł23.59
24h
Available quantity: 5
Available
The Step-Down D24V6F5 Buck Voltage Regulator module gives the output voltage of 5V with a wide input voltage range of 7-42V and a maximum output current of 600 mA. Pololu 2107
zł41.72
24h
Available quantity: 1
Available
DC-DC Step-Up converter U3V40F7 with an output voltage of 7.5 V, an input voltage of 1.3 to 7.5 V and a maximum output current of 4 A. Pololu 4014
zł44.74
24h
Available quantity: 4
Available
The Step-Down D24V3F9 Buck Voltage Regulator module gives the output voltage of 9V with a wide input voltage range of 11-42V and a maximum output current of 300 mA. Pololu 2099
zł34.77
4 weeks
No product available!
The DC-DC Step-down Converter Module with the LM2596S chip allows you to convert the voltage from the range of 3-40 V to a regulated output voltage of 1.5-35 V with high efficiency up to 92%. The maximum output current is 3 A, and the operating frequency is 150 kHz. The compact design with dimensions of 43 × 21 × 14 mm, the possibility of precise voltage regulation and a pinout of 2.54 mm facilitate the integration of the module in DIY projects, power supply systems, modeling and laboratory stations. The operating temperature range is from -40 to 85°C
zł5.90
24h
Available quantity: 693
Available
A power supply based on a DC-DC converter with a current capacity of up to 6.1 A. The input voltage can range from 6 V to 30 V, while the output voltage is adjustable from 0 V to 36 V. Enclosure version. XYL3606S
zł193.42
24h
Available quantity: 4
Available
An efficient step-down converter that reduces the input voltage to 3.3 V at a maximum current of 100 mA, offering high efficiency thanks to its low quiescent current (<20 μA). It supports input voltages from 3.3 V to 65 V, has short circuit and overheating protection, making it a reliable and energy-efficient solution. Pololu 5362
zł21.21
24h
Available quantity: 5
Available
Step-Down DC-DC converter module based on the D36V6F3 system. Input voltage 4 ... 50V, output voltage 3.3V (max. 600mA). Polol 3791