Category: RETIRED PRODUCTS

PCB board and programmed circuit for a simple digital thermostat. AVT1878 A +

Assembled simple digital thermostat. AVT1878 C

PCB board and programmed circuit for the start-stop time relay. AVT1879 A +

Assembled start-stop time relay. Ideally suited as a controller for lighting, heating or ventilation ventilation. AVT1879 C

AVT kit for self-assembly of the ON / OFF timer. AVT1821 B

Assembled ON / OFF timer. AVT1821 C

AVT kit for self-assembly of a digital thermostat. AVT5441 B

PCB board and programmed system for the temperature indicator for the central heating furnace. AVT1830 A +

Intenso Pendrive with a capacity of 32 GB equipped with a USB 2.0 interface. Maximum read speed: 28 MB / s, maximum write speed: 6 MB / s

SanDisk micro SDHC memory card with a capacity of 16 GB, a maximum write speed of 12 MB / s, a maximum reading speed of 18 MB / s.

The module with the DS18B20 sensor is used to measure the temperature in the range from -55° C to + 125° C, with an accuracy of +/- 0.5° C in the range from -10° C to + 85° C. The module communicates via the 1-Wire interface, thanks to which it can be connected using 2 or 3 wires - depending on the configuration. Temperature measurement can be performed with an accuracy of 9 to 12 bits. MOD-31.Z

It is a standard audio-video cable, which can be successfully used to connect Banana Pi M1 or Raspberry Pi 1 model B and A. Cable length is 98 cm, has two ends of the chinch type.

The I2C electric level conversion module is specifically designed for Banana Pi. The module converts the 3.3V of I2C electric level to 5V level or converts 5V to 3.3V

BPI AD/DA extend module with the PCF8591 single-chip, single-supply low-power 8-bit CMOS data acquisition device with four analog inputs, one analog output and a serial I2C-bus interface

Antena 3 DB do Banana Pi R1

5dB antenna for the Banana Pi R1 router in the version with 300Mps wifi and five LAN 100/1000 ports.

STM32F103 programming cable for Open Debugger Burn Board and Banana Pi G1 connection

CC3200 programming cable for Open Debugger Burn Board and Banana Pi G1 connection

CC2530 and CC2540 programming cable for Open Debugger Burn Board and Banana Pi G1 connection

COM-11964 Button a white economy grade 100mm diameter (outside diameter) dome illuminated push button comes with an LED, securing nut and a long life horizontal microswitch.