Category: RETIRED PRODUCTS

HK RGB LED Flexible Strip with 4-pin Driver Connector 1m (Red / Green / Blue) (17407)

HK Clear Foam Glue (Medium Cure) - Large 100ml (17535)

Helicopter micro remote controlled, coaxial, 2.4Ghz, 4-channel, Dual-mode transmitter, RTF (HK17580)

HK HobbyKing 1500mAH LiFe 3S 9.9v Transmitter pack. (17955)

Rick Anderson, Dan Cervo

Xilinx Kintex®-7 XC7K325T-1FFG676 FPGA. 6015-410-001-KIT

COM-12656 - EasyVR Shield 2.0 - Voice Recognition Shield, RoHS

MYD-AM3359 Development Board, MYIR

Integrated, built-in SOM (System on Module) ARM system, equipped with TI AM3352 processor with ARM Cortex-A8 core, 512 MB DDR3 SDRAM, 512 MB Nand Flash and Gigabit Ethernet PHY and interfaces supporting PRU / ICSS protocols in real time. MYiR MYC-AM3352

(E000037) Arduino Intel Galileo

Compatible with XU / XU3 / XU4 Series

Wide Input Voltage 3.0 A Step Down Regulator, SOIC8, RoHS, Allegro MicroSystems

Low-cost Phase-control IC with Soft Start, SO8, RoHS, Temic Semiconductor

The low loss, intelligent IPM module of the SLLIMM ™ STMicroelectronics series: three-phase inverter bridge with a maximum current of 30A and 600V voltage, IGBT technology. The system has an SDIP25L housing

Simon Monk

Cable with USB plugs type A and USB type B, cable length 1m

It is used to monitor the temperature measurement and other parameters. The expansion module has an I2C / 1-Wire converter (DS2482) through which DS18B20 temperature sensors can be connected using two or three wires. MOD-29.Z

MOD-33 / AZ

The module with the DS18B20 sensor is used to measure the temperature in the range from -55° C to + 125° C, with an accuracy of +/- 0.5° C in the range from -10° C to + 85° C. The module communicates via the 1-Wire interface, thanks to which it can be connected using 2 or 3 wires - depending on the configuration. Temperature measurement can be performed with an accuracy of 9 to 12 bits. MOD-31.Z