Category: RETIRED PRODUCTS

Robot controller dedicated to Totem sets. It is based on the ESP32 chip (WiFi and Bluetooth module), equipped with a DC motor and servo driver, RGB diodes and an IMU sensor. Totem TE-X4-KIT1

Thermally conductive tape used as a replacement for thermally conductive paste. They are very flexible and characterized by high compressibility. AG Termopasty ART.AGT-161

Li-Po battery with a rated voltage of 3.7 V and a capacity of 1350 mAh, equipped with a PCM protection and a 1.5 JST-ZH connector. Akyga LP503758

External enclosure designed to protect, transfer and store data on 2.5” HDD and SSD drives with SATA interface. UGO UKZ-1531

Kit for building a dog robot controlled by a wire with a switch. Totem TKR-DG

128 GB Hynix SSD. It is equipped with NVMe PCIe 3.0 interface with M.2 B&M Key connector. Hynix HFM128GDHTNG-8310A

Samsung 980 SSD 250 GB. It is equipped with NVMe PCIe 3.0 x4 interface with M.2 M Key connector. Samsung MZ-V8V250BW

External case designed to protect, transfer and store data on M.2 SSD drives with SATA interface. GEMBIRD EE2280-U3C-01

Module with e-Paper display with a diagonal of 2.13" and a resolution of 250x122 px with WiFi communication and Bluetooth 4.2. Waveshare 2.13inch e-Paper Cloud Module

LoRa module based on ESP32-WROOM-32E with WiFi and Bluetooth communication and LoRa RFM95W modem. There are ESP32 pins and a Qwiic connector on the board. SparkFun WRL-18074

A module with a MEMS microphone and an amplifier that will allow you to detect a voice, a clap or a door slam. The board has an analog output. SparkFun BOB-18011

Base board for the SpaceSOM-8Mplus family of modules. Creates a complete development platform similar to the SBC. SoMLabs SpaceCB-8Mplus-ADV v.1.1

HAT expansion module with SATA interface designed for Raspberry Pi 4 model B. It allows you to connect to a minicomputer mass storage in the form of 2.5" HDDs and SSDs with SATA interface

Kit for building a giraffe robot controlled by a wire with a switch. Totem TKR-GRF

A set for building a 6-legged walking robot controlled by a mobile application. Totem TKR-LDB

A spatula for removing prints from the 3D printer table. Made of stainless steel, it is durable and handy

The MIMXRT1176DVMAA dual-core evaluation kit that runs up to 1 GHz has 512 Mb SDRAM, 512 Mb Flash, and 128 Mb QSPI Flash. NXP MIMXRT1170-EVK

A set of two cameras with a Sony IMX219 sensor, allows you to rotate the camera and control the tilt angle. Works with Jetson Nano and Xavier NX. The camera is equipped with an 8MP matrix. ArduCAM B0191PT

2500 mW laser head designed for installation in a CNC machine. It allows you to engrave in materials such as wood, plastics, paper or thin leather. CNClaser2500mW

A LiDAR camera with a small size and a resolution of 2 MP equipped with an IMU unit. It enables very accurate depth detection. Range up to 9 meters. Intel RealSense LiDAR Camera L515