Category: STARTER KITS, PROGRAMMERS, MODULES

Module with 512 kbit (64kB) EEPROM. Communication is via the I2C interface. The module has 3 jumpers to select one of 8 addresses. SparkFun COM-18355

Flexible 4-core cable, 500 mm long, terminated on both sides with a Qwiic plug. Sparkfun PRT-17257

Tomasz Frenchman

The X-NUCLEO-IHM03A1 plate allows the control of a high-power stepper motor; the maximum current of the phase is 10A rms, additionally the controller enables execution up to 1/128 step and has a number of protections. X-NUCLEO-IHM03A1

Ethernet module dedicated to Coral Dev Board Micro. It supports power over Ethernet (PoE) technology and connects to the base board via B2B connectors. Coral G650-07975-01

Extension board designed for MicroMod main modules. It is equipped with a Qwiic connector and two places for attaching Qwiic plates. SparkFun DEV-17724

Bluetooth 5.2 communication kit. It uses the STM32WB15CC microcontroller (320 kB Flash, 48 KB SRAM, ARM® Cortex®-M4 and Cortex®-M0+). STMicroelectronics NUCLEO-WB15CC

Hub with Qwiic connectors that allows you to connect several boards to the evaluation kit. There is no built-in control system, but only splits one connector into 3 more. SparkFun BOB-18012

Module with WiFi Espressif ESP32-S2 WROOM. It integrates a set of peripheral devices - capacitive touch sensors, SPI, UART, I2S and I2C. SparkFun WRL-15663

STM32 Nucleo-32 development board with STM32F042K6T6 MCU, supports Arduino connectivity

Module with a passive buzzer designed for M5Stack sets. It is equipped with a Grove connector and is controlled by a square signal. M5Stack U132

Extension board X-NUCLEO-IHM04A1 for STM32 Nucleo, with dual brush motor controller, operating based on the L6206 system

Shield for STM32 Nucleo that allows you to add the possibility of operating a three-phase brushless motor (BLDC) or synchronous permanent magnet (PMSM). It uses the L6230 chip for control. X-NUCLEO-IHM07M1

The Sipeed RV Debugger Plus is a compact RISC-V BL702 programmer/debugger featuring JTAG and USB-TTL interfaces, ideal for debugging bare metal, UBOOT, and Linux environments

Dreamer Nano V4 - Arduino Leonardo compatible; ATmega 32U4

Extension module with Li-Ion and LiPo charger dedicated to QT Py boards. It allows you to charge the batteries with a current of up to 200 mA. Adafruit 5397

A module with a set of environmental sensors (pressure, temperature and humidity sensor, light sensor, MEMS microphone) designed for micro:bit. Pimoroni PIM355

Miniature development board with ATtiny817 microcontroller. It has analog inputs, PWM outputs and two STEMMA QT connectors. Adafruit 5233

Expansion module compatible with micro:bit. The board is equipped with a 24 V 2 A relay, two buffer inputs, two sink outputs and three analog inputs with a working range up to 24 V. Pimoroni PIM371

Development board with RP2040 microcontroller. Equipped with a microBUS connector, it can work with Qwiic expansion boards. SprakFun DEV-18721