Category: STARTER KITS, PROGRAMMERS, MODULES

Module with a TDS sensor that allows you to measure the total content of solids dissolved in water. The board is equipped with a Grove connector and communicates via an analog interface. Seeed Studio 101020753

Module with 8x8 LED matrix in red and HT16K33 LED driver. The board is equipped with a Grove connector and communicates via I2C. Seeed Studio 104020089

A set with environmental sensors that allows you to measure air pollution and noise and visualize data on a dedicated platform. Seeed Studio 102110258

Module with a 9-axis IMU sensor, which combines an accelerometer and a gyroscope (ICM20600 system) and a magnetometer (AK09918 system). The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 101020585

Module with a button and RGB LED backlight. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 111020049

Module with 6-position DIP switch. The board is equipped with a Grove connector and communicates via I2C. Seeed Studio 111020043

Module with 8 relays SSR G3MC202P with a load up to 2 A. The board is equipped with a Grove connector and communicates via I2C. Seeed Studio 103020136

Module with relay SSR G3MC202P with a load up to 2 A. The board is equipped with a Grove connector and is controlled via digital input. Seeed Studio 103020137

Module with LCD display 16x2 characters. The board is equipped with a Grove connector and communicates via UART. Seeed Studio 104020004

Module with a BME680 sensor that allows you to measure temperature, humidity, pressure and gas detection. The board is equipped with a Grove connector and communicates via I2C and SPI. Seeed Studio 101020513

Module with air quality sensor SGP30. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 101020512

Module with a 3-axis magnetometer BMM150. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 101020492

Starter kit with Grove modules, which allows you to see the possibilities of the Azure platform. Seeed Studio 110060742

Module with RGB LED diode. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 104020048

Module with a SI1145 light sensor that can detect waves with a wide range of wavelengths: UV, visible and infrared light. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 101020089

Module with a MLX90640 thermal imaging camera with a 32x24 field matrix and a 55° viewing angle. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 114020141

Kit with MPX5700AP pressure sensor, syringe and tube. The board is equipped with a Grove connector and communicates via an analog interface. Seeed Studio 110020248

Extension module for Raspberry Pi. It allows you to control two DC motors, support encoders, 4 servos, IMU 9DoF and connect Qwiic modules. SparkFun ROB-16328

Starter kit with micro:bit v2. In addition to the micro:bit v2 board, the set includes a microUSB-USB cable, a battery basket and two AAA batteries. SparkFun DEV-17288

Evaluation kit with LittleBee GW1NR9 FPGA. It offers 8640 LUTs, 6480 Flip-Flops (FF), and has a built-in 8MB (64Mb) SDRAM. The board has 8 MB Flash, FTDI for UART, 8 LEDs and a button. TEC0117-01