Category: STARTER KITS, PROGRAMMERS, MODULES

Module with an analog MQ6 propane sensor. It is powered with the voltage of 5 V and has an analog output. DFRobot SEN0131

Module with a transmitter designed for communication via a laser beam transmitted in the air. M5Stack Laser.Tx Unit

Soil moisture sensor with analog output. The probe has two pointed tabs, making it easy to insert into the ground. It is supplied with the voltage of 3.3V or 5V. DFRobot SEN0114

Waterproof soil moisture sensor with analog output. The probe has a pointed tip, which allows it to be easily inserted into the ground. It is supplied with the voltage from 3.3V to 5.5V. DFRobot SEN0308

A set with a prototype breadboard equipped with a Grove connector. Seeed Studio 103020232

Starter kit with nRF52840-MDK evaluation board and Grove modules designed for the development of Mesh networks. Seeed Studio 110061007

Module with LCD display 16x2 characters with blue backlight. It is supplied with the voltage from 3.3 V to 5 V and communicates via the I2C interface. DFRobot DFR0555

Module with LCD display 16x2 characters with gray backlight. It is supplied with the voltage from 3.3 V to 5 V and communicates via the I2C interface. DFRobot DFR0557

Prototype kit for use in industry. It includes a prototype board with an M-BUS connector, TTL-RS485 converter, connectors and a DIN rail. M5Stack Base26

Set of 10 cables, 30 cm long, for digital sensors compatible with the Gravity standard. DFRobot FIT0011

A module with a magnet sensor that allows you to detect the presence of an object emitting a magnetic field in the environment. The module is supplied with the voltage ranging from 3.3 V to 5 V and has a digital output. DFrobot DFR0033

Module with PM2.5 HM3301 dust sensor. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 101020613

Module with a PIR motion sensor. It can detect movement up to 7 meters with a detection angle of 100 degrees. DFRobot SEN0171

Development kit with ATSAMD51J20 microcontroller with ARM Cortex M4F core. It is clocked at 120 MHz, has 1 MB of Flash and 256 KB of SRAM. There are 6 SERCOM interfaces on the board. SparkFun DEV-14713

Module with an analog light sensor. It consists of a photoresistor and a LED. Equipped with a Gravity connector. DFRobot DFR0022

The IO expansion module is designed to work with the micro:bit educational board. There are 20 GPIO pins on the board, a buzzer and a voltage stabilization circuit

Module with digital temperature sensor TMP102. It enables temperature measurement in the range from –40°C to 125°C with an accuracy of 0.5°C. The system communicates via the I2C interface. SparkFun SEN-16304

Development kit with ATSAMD21E microcontroller with ARM Cortex M0+ core. The chip can be clocked at 48 MHz, has a built-in 256 KB of Flash memory and 32 KB of SRAM. The module has a Qwiic connector. SparkFun DEV-15423

Module with an EMG signal detector. The board is equipped with a Grove connector and has an analog output. Seeed Studio 101020058

Module with a microswitch (limit switch). The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 111020044