Category: STARTER KITS, PROGRAMMERS, MODULES

The STM32 Nucleo-32 boards provide an affordable and flexible way for users to try out new concepts and build prototypes with the STM32 microcontrollers, choosing from various combinations of performance, power consumption and features.

The base board for the Wi-Fi NodeMCU module (ESP-12E), thanks to the built-in L293DD system, allows for attaching e.g. motors, electromagnets or other executive devices. The I/O lines of the NodeMCU module were derived to the pin connectors, and the power supply can be connected with the use of screw connectors. ESP12E Motor Shield

Starter kit with micro:bit v2. In addition to the micro:bit v2 board, the set includes a microUSB-USB cable, a battery basket and two AAA batteries. SparkFun DEV-17288

Rod antenna 2.4G, gain 5dBi, connector type: IPEX/U.FL, RoHS

Base board for dipPLD modules with XC2C256 (CoolRunner-II by Xilinx)

Cable that allows you to attach the ATMEL-ICE programmer to the development kit with any connector (supported by the programmer), via single pin plugs (goldpin)

Evaluation kit equipped with STM32F411CEU6 microcontroller (ARM Cortex M4, 100MHz, 512kB Flash, 128kB RAM). It has two 20-pin connectors enabling the use of numerous microcontroller peripheral systems.

The Espressif ESP32-S3-WROOM-1 WiFi and Bluetooth LE module board offers 8 MB Flash memory and 8 MB PSRAM. The pinouts are compatible with the ESP32-S3-DevKitC-1 modules.Waveshare ESP32-S3-DEV-KIT-N8R8

Rafał Chromik

Small evaluation board based on the ATmega328, RoHS

JTAG interface for microcontrollers with ARM core

12V/2A Power Supply Unit EU for Odroid HC2

Audio module designed for Teensy 4.0 and 4.1. It uses the SGTL500 audio codec chip with I2S interface, it can work with a microSD card or SPI Flash memory. Audio Adapter Boards for Teensy 4.x (Rev D)

A small USB-UART TTL converter module based on the CH340 system with a USB type A connector. Designed for the ESP-01 and ESP-01S modules

Marcin. Bonds

Wi-Fi antenna with a length of 100 mm. It operates in two frequency ranges: 2.4 and 5 GHz. Profit: 3 dBi; 4.5 dBi

Riverdi RVT70HSTFWCA0 TFT LCD display module with a diagonal of 7" and a resolution of 1024x600 pixels equipped with a capacitive touch panel, DC/DC converter and protective glass. It communicates via an RGB parallel interface. SoMLabs SL-TFT7-TP-600-1024-RGB v.1.1

Arduino development board with RP2040 microcontroller. Equipped with WiFi and Bluetooth module, 6-axis IMU system with accelerometer and gyroscope, MEMS microphone, RGB LED diode and cryptographic system. Arduino ABX00052

Starter kit from the NUCLEO series equipped with the STM32H723ZG microcontroller (1 MB Flash, Cortex-M7), with a built-in programmer-debugger ST-Link/V3, equipped with connectors compatible with Arduino. STMicroelectronics NUCLEO-H723ZG

Wi-Fi module based on the ESP8266 system - simplicity of use (communication through UART, supports AT commands), 3.3V power supply, support for WPA / WPA2 encryption - these features make the EPS8266 module applicable anywhere, where reliable and effective data transmission. The module is not equipped with an antenna, it should be attached using the U.FL connector. ESP-05