Camera module based on the CMOS MT9N001 matrix with a resolution of 3488x2616 px (9 MPx). Designed for use with ArduCAM USB Shield. ArduCAM B0098

1m USB A-microB USB cable, white-blue cable, flat red plugs illuminated with RGB diode

Monochrome camera module based on CMOS MT9M001 matrix with a resolution of 1280x1024 px (1.3 MPx). Designed for use with ArduCAM USB Shield. ArduCAM B0159

Camera module based on CMOS MT9M001 matrix with a resolution of 1280x1024 px (1.3 MPx). Designed for use with ArduCAM USB Shield. ArduCAM B0160

2.4 "TFT LCD touch screen with 320x240 pixel resolution, ILI9341 display controller (SPI interface). The module is additionally equipped with a micro-SD card slot. Adafruit 2478

Air quality sensor module based on the SGP40 system. It uses CMOSens technology by Sensirion and provides information on the concentration of volatile organic compounds (VOC). Adafruit 4829

Module with E-Ink (e-Paper) display with a diagonal of 2.13" and a resolution of 250x122 px. Designed for minicomputers Raspberry Pi. Adafruit 4687

Module with a digital barometer LPS22. It enables pressure measurement in the range from 260 to 1260 hPa and communicates via I2C or SPI. Adafruit 4633

Translator of TI voltage levels, bidirectional (no signal required to control the flow direction), 8-Bit, especially recommended for use in Push-Pull and Open-Drain systems. The system has a TSSOP20 housing

The SST Liquid Level Sensor provides single point liquid detection via a TTL compatible push/pull output. This optical liquid level sensor features a miniature design that allows for installation in areas where space is limited. SEN-13835

Temperature and humidity sensor module based on the HTS221 chip. Equipped with a STEMMA QT connector, it communicates via an I2C or SPI interface. Adafruit 4535

IS31FL3731 LED Matrix Opto Feather Platform Evaluation Expansion Board. COOL WHITE matrix. Adafruit 3138

Camera designed for RP2040 development boards. It uses the Himax HM0360 sensor with a resolution of 640x480 px. ArduCAM B0336

32-bit ARM Cortex-M0 microcontroller; up to 32 kB flash; up to 10 kB SRAM and 4 kB EEPROM; USB device; USART, LQFP48, NXP

Bluetooth 4.0 module based on the CSR8635 chip designed for Bluetooth audio applications. The module has a built-in antenna and pins for edge connectors.

Module with waterproof barometer LPS33HW. It enables pressure measurement in the range from 260 to 1260 hPa and communicates via I2C or SPI. Adafruit 4414

ARM7TDMI, 512kB Flash (ISP), 32kB RAM, USB 2.0, ADC, DAC, 2xUART, 2xI2C, SPI, LQFP64, RoHS

Module with an analog MQ7 carbon monoxide sensor. It is powered with the voltage of 5 V and has an analog output. DFRobot SEN0132

Camera with OV7251 CMOS sensor with a resolution of 640x480 px. Equipped with a snapshot, it communicates via 1-lane MIPI interface. ArduCAM U6070-1