Antenna with RP-SMA male plug operating in the 433 MHz frequency band. It has a gain of 3 dBi

Module with an EMG signal detector. The board is equipped with a Grove connector and has an analog output. Seeed Studio 101020058

Connect your Arduino-compatible to the Internet with this WiFi shield that features the FCC-certified ATWINC1500 module from Atmel. Adafruit 3654

Connect your Arduino-compatible to the Internet with this WiFi shield that features the FCC-certified ATWINC1500 module from Atmel. Adafruit 3653

Extension board with distance sensor ToF VL53L1, The sensor has a range of up to 400 cm. The kit includes 2 modules with sensors that can be connected via a 10-pin connector. The shield is compatible with STM32 Nucleo boards and has an Arduino UNO R3 connector. STMicroelectronics X-NUCLEO-53L1A2

This add-on board makes it easy to control two high-power DC motors with a Raspberry Pi. Its twin discrete MOSFET H-bridges support a wide 6.5 V to 30 Voperating range and are efficient enough to deliver a continuous 18 A without a heat sink. The drivers offer basic current limiting functionality, and they accept ultrasonic PWM frequencies for quieter operation. 

Module with 4-channel ADC ADS1015 converter. The system enables analog voltage conversion for both single signals (11-bit resolution) and differential signals (12-bit resolution). I2C communication. SparkFun DEV-15334

LED strip with COB diodes in white (neutral). It is powered by 12 V DC, has a length of 1 m and 384 LEDs/m. Protection level IP20

3-color e-Paper display with a diagonal of 4.2" and a resolution of 400x300 px. SPI interface. No PCB. Waveshare 4.2inch e-Paper (B)

LED strip with COB diodes in green. It is powered by 12 V DC, has a length of 5 m and 384 LEDs/m. Protection level IP20

This shield makes it easy to control two high-power DC motors with your Arduino or Arduino-compatible board. Its twin discrete MOSFET H-bridges support a wide 6.5 V to 30 V operating range and are efficient enough to deliver a continuous 18 A without a heat sink.

Universal silicone cover that protects the LED strip against moisture, water and dirt. Provides protection in accordance with the IP67 standard

OLED display with a diagonal of 1.3" and a resolution of 128x64 pixels. Designed for use with Feather series plates. Adafruit 4650

LED strip with COB diodes in white (warm). It is powered by 12 V DC, has a length of 5 m and 384 LEDs/m. Protection level IP20

Intelligent RFID identifier cooperating with iNode Control Point

Intelligent relay cooperating with iNode Control ID

Air quality sensor module based on the SGP40 system. It communicates via the I2C interface. DFRobot SEN0392

The module allows the existence of devices with BLE in networks with the Ethernet protocol, has a BT2.1 receiver