Module with a mechanical encoder and RGB backlight in the form of 24 colorful LEDs. It offers five buttons and a rotary encoder. For communication, it uses a Qwiic/Stemma QT connector or a connector compatible with the Breakout Garden system. It is perfect, for example, for controlling lighting. Pimoroni PIM673

Module with a 7-color ACeP e-Paper display with a diagonal of 7.3" and a resolution of 800 x 480 pixels. It is equipped with a 40-pin GPIO connector and can work with Raspberry Pi minicomputers. It communicates via the SPI interface. Pimoroni PIM667

Transparent prototype contact board with 400 points, dimensions 82x55x10 mm, with double-sided adhesive tape. PPS0400T

IPS LCD display with a touch panel with a screen diagonal of 11.9". It offers a resolution of 320 x 1480 pixels and an HDMI input, which allows you to easily connect the display to various signal sources. Waveshare 11.9inch Touch Monitor

The 1.3 "LCD display and 168 x 144 pixel resolution is a combination of an e-ink display (e-paper) with LCD display, which is characterized by extremely low energy consumption by the eInk system and fast refresh of the LCD display. Adafruit 3502

Pin header, 20 pin, 2,54mm

The module with the four-bit logic translator TXB0104, can work in both directions. Connections using standard goldpin connectors with 2.54 mm pitch. It is compatible with BOB-11771

The magnetic holder is an ideal solution for mounting small USB monitors or phones. It provides a stable grip and is easy to install. Waveshare Magnetic Holder

The Tic T825 USB Multi-Interface Stepper Motor Controller makes basic control of a stepper motor easy, with quick configuration over USB using our free software. The controller supports six control interfaces: USB, TTL serial, I²C, analog voltage (potentiometer), quadrature encoder, and hobby radio control (RC). 

RGB LED matrix display with a resolution of 64x32 (2048 LEDs). It has a HUB75 interface and can work with Raspberry Pi, Arduino or ESP32. Waveshare RGB-Matrix-P5-64x32

WS2812B

LED display 14,20mm 0,56 "single, ultra-red (635nm), 40 mcd (20mA), common anode. LED1-AS-05613BMR-B PBF

LM4950TS, audio amplifier, 3.1 W; 9.6 to 16 VDC; 2 channels; Class AB, TO-263

Installation connector, 5-wire, 450 V, 32 A, with levers. Wago 221-415

74HC595D, 8-bit serial-in, serial or parallel-out shift register with output latches; 3-state, SO16

The SMA male crimp connector for cable is a standard connector used in a wide range of radiocommunication and electronic devices. It is made of anodized brass. It has an impedance of 50 Ω, which is a standard parameter for many radio communication systems

The SMA female crimp connector for cable is a standard connector used in a wide range of radiocommunication and electronic devices. It is made of anodized brass. It has an impedance of 50 Ω, which is a standard parameter for many radio communication systems

Laser scanner using 360-degree measurement, taking samples at a frequency of up to 16 kHz. It is capable of generating 2D point map information within a 12-meter radius. Seeed Studio 114110128

DFRobot SEN0153

ST485BDR is a low-current RS-485/RS-422 transceiver with one transmitter and one receiver, enabling bidirectional half-duplex communication. It is characterized by low current consumption (300 µA) and protection against overload and overheating, which makes it ideal for various industrial applications.