Category: ELECTRONICS

Module with MLX90614-DCI sensor for non-contact temperature measurement in the range from -70℃ to 270℃. I2C communication. DFRobot SEN0263

The fan designed for use with the Digilent ZYBO Z7-20 plate mounted on the heat sink allows better air flow, which results in lowering the FPGA temperature. The fan has a 3-pin connector, the supply voltage is 5 V. In addition to the fan, there are screws for fixing. Digilent 240-130

EEPROM memory in SOIC-8 package. The chip has 32 kb memory (4k x 8 bits). Communication takes place via the I2C interface. ON Semiconductor CAT24C32WI-GT3

Camera module with IMX290 sensor with a resolution of 2 MPx dedicated to the Raspberry Pi. Equipped with an IR-CUT filter. Waveshare IMX290-83 IR-CUT Camera

Advanced expansion board for Arduino. It has support for mini-SIM cards and NB-IoT cards. Thanks to the GNSS module (Global Navigation Satellite System), it supports GPS, GLONASS, Galileo, QZSS and BeiDou GPS navigation systems. The module is powered by 7-12V voltage. DFRobot DFR0572

2x16 character LCD display. It can display the font in any color from the RGB palette. Communication via the I2C interface. The module has a lead compliant with the Gravity standard. DFRobot DFR0554

Camera module with USB interface. Equipped with a CMOS IMX179 sensor with a resolution of 8 MP and a lens with a viewing angle of 145°, it has a built-in microphone. Waveshare IMX179 8MP USB Camera (A)

Camera module with USB interface. Equipped with a CMOS OV2710 sensor with a resolution of 2 MP and a lens with a viewing angle of 145°. Waveshare OV2710 2MP USB Camera (A)

Connection for temporary fixing of TC2050-NL cable on the printed circuit board. The solution will be used when you need to perform a programming or debugging process in a circuit. Tag-Connect TC2050-CLIP

Module with a capacitive fingerprint reader with UART and USB interface. Waveshare Capacitive Fingerprint Reader

Bluetooth 4.0 BLE module powered with 3.3V voltage based on SOC TI CC2541 (On Chip). The module has a range of up to 10m and communicates via the UART interface.

Module with a proximity sensor operating in the infrared band. It allows you to detect obstacles in the range of 2 to 30 cm. Waveshare Infrared Proximity Sensor

A UART-Ethernet converter that provides easy communication between the UART TTL serial interface and RJ45 Ethernet. Configurable via website or AT commands. Waveshare UART TO ETH

Extension module with a driver for two stepper motors based on the DRV8825 system. Dedicated for Raspberry Pi minicomputers. Waveshare Stepper Motor HAT

WIFI-LPB100-A module Eval Kit enables UART data transmission via WiFi, ultra low power consumption, encrypted communication

ARK terminal connector spring 3-pin, pitch 5.00 mm, non-detachable

LC filter connected to the output of the DC power supply with a voltage from 0 to 50 V and a maximum current of 3 A. It reduces voltage ripple and interference caused by the power supply

Integrated circuit - temperature sensor; working temperature from -40 to 100 ° C; TO92; THT, STMicroelectronics. Accuracy ± 1 ° C

Black and white e-Paper display with a diagonal of 3.52" and a resolution of 360x240 px. Communicates via the SPI interface. Without a PCB. Waveshare 3.52inch e-Paper

LoRaWAN SX1303 module is equipped with a Mini-PCIe connector. It uses the SPI or I2C interface for communication. Waveshare SX1303 868M LoRaWAN Gateway (B)