STM32L552RET6, Ultra-low-power with FPU Arm Cortex-M33 with Trust Zone, MCU 110 MHz with 512 kbytes of Flash memory, LQFP64

FFC tape enabling seamless connection of DSI displays with the Raspberry Pi 5 minicomputer. Black EMI shielding foil on both sides of the tape increases anti-interference efficiency, protecting signals against interference from the environment. Waveshare Pi5-Display-Cable-200mm

The 46.52 and 46.61 miniature industrial relays offer high reliability and versatility of use, meeting the requirements of traction standards and ensuring ease of installation and operation. Finder 46.52.8.230.0040

Carrier board dedicated to Raspberry Pi CM4 modules. It is equipped with two Ethernet connectors, a microSD slot and a USB connector. It allows you to build a small router. DFRobot DFR0767

Step-up DC-DC converter module, 0.9-5V input voltage, 5V output voltage (max. 600 mA) connected to the USB socket. There is a diode on the board indicating the power connection. modPS

1A, 97% Efficiency, 30µA Quiescent Current Step-Up Converter with True Shutdown, tdfn10-ep, Maxim Integrated, RoHS

Audio receiver with Bluetooth 5.0 communication based on the QCC3008 module. It is equipped with an insulated converter that enables power supply with 5 V voltage

15 cm long cable with plug and XT60 socket. It allows you to connect a battery with an XT60 socket, e.g. to a charger

Cable with USB type A and USB type C 2.0 plugs, cable length 1 m

LoRa module with RP2040 microcontroller. It uses the SX1262 chip, ensuring reliable long-distance communication in the frequency range from 410 to 525 MHz. Waveshare RP2040-LoRa-LF

Access line ultra-low-power 32-bit MCU ARM®-based Cortex®-M0+, 64 KB Flash, 8 KB SRAM, 2 KB EEPROM, ADC, LQFP48, RoHS

Camera with a resolution of 8 MPx with a USB interface. Equipped with a CMOS IMX219 sensor with a lens with a viewing angle of 60° and an autofocus function. ArduCAM B0292

A module with line sensors designed to work with the Kitronik kit. It has two sensors in the form of phototransistors that generate an analog voltage that can be read by the microcontroller. The module is equipped with a 4-pin connector (3V, 0V, L, R), which allows for power supply and reception of signals from the sensors, and the output voltage changes depending on the detected surface, which allows it to be used not only with the Kitronik kit, but also with platforms such as Arduino or Raspberry Pi Pico. Kitronik 56111

32-bit microcontroller from the STM32L4 family (low power series) with ARM Cortex-M4 core, 128kB Flash memory, 40kB RAM, clock speed up to 80MHz and I2C, SPI, UART / USART interfaces, USB FS, LIN, IrDA, I2S, DMA , Motor Control PWM, Temp Sensor, WDT, A / D 10x12b in the LQFP48 housing. STMicroelectronics STM32L412CBT6

Kinetis L Series Cortex-M0+, 32bit MCU, 32kB Flash, LQFP64, Freescale, RoHS