Soil moisture sensor with analog output. It has a probe with pointed tips, which allows you to easily place it in the ground. The analog output voltage level increases in proportion to the humidity level

Quad 2-input NAND Schmitt trigger, SOP14, RoHS

The 205G-DEN0 connector combines two USB 2.0 ports and one HDMI 1.4 port in a single right-angle PCB-mount housing. Designed for devices requiring both data and video signal connections, it is suitable for multimedia systems and modern consumer electronics.

Cloverleaf Power Cable Brand Lanberg with CEE 7/7 to IEC C320 C5. Lanberg CA-C5CA-11CC-0018-BK

Photodiode Brightness Sensor Module, RoHS

A 20 cm long 5-pin cable with a JST XH2.5 male plug on one side

Connector for connecting the 16-pin tape with 0.5 mm pitch to the printed circuit board

Development board D1 Mini with WiFi module ESP-8266MOD and 4 MB Flash memory. The module can be programmed from the Arduino IDE level. WeMos D1 Mini

Limit switch with lever, 250VAC, 1A, SPDT, ON- (ON), RoHS

Industrial Ethernet module that allows control of 30 relays via RJ45 port. It uses Modbus TCP protocol, PoE (Power over Ethernet) power supply and comes with a rail-mounted housing. Waveshare Modbus POE ETH Relay 30CH

A large momentary button with a diameter of 100 mm with LED backlight. Yellow color

RS485 CAN HAT is an extension designed for the Raspberry Pi mini-computer in the form of a HAT overlay. Adds RS485 and CAN interfaces for the Raspberry Pi plate. Interface signals are derived as screw and goldpin connectors. RS485 CAN HAT

ARM Cortex-M0 CPU, 32kB Flash, 4kB RAM, 1xUART, 1xI2C, 1xSPI, ADC, TSSOP20, STM, RoHS

Pin strip straight in blue, single-row, extended, female, 1x6, pitch 2.54mm, THT, RoHS. PB06S L BLUE. Set of 10 pieces

Shielded FTP category 6 Ethernet network cable with RJ45 plugs. Lanberg PCF6-10CC-0100-G

Adapter form IDC10 1,27 mm used on laser dust sensor PMS7003 to 2,54 mm goldpin. It helps with connecting sensor to standard breadboard or development boards (Arduino, STM32 etc.). It can be connected to PMS7003 easily, as connector fit with sensor\'s outputs

Two-way loudspeaker crossover with a crossover frequency of 3200 Hz. It works with speakers with an impedance of 4 to 8 Ω and offers power up to 120 W

The module containing 8 individually controlled WS2812 RGB diodes enables the creation of effective light sequences with precise color and brightness management. Powered by 5 V and communicating via a single-line digital interface, it can be easily integrated with popular microcontroller platforms. Thanks to the possibility of serial connection, it is used in decorative, signaling and educational projects, offering great flexibility while maintaining simplicity of use

Male terminal block, angled, 11-pin. Pitch 3.5mm. Height 9.2mm. KF2EDGR. Set of 5 pieces.