A module with line sensors designed to work with the Kitronik kit. It has two sensors in the form of phototransistors that generate an analog voltage that can be read by the microcontroller. The module is equipped with a 4-pin connector (3V, 0V, L, R), which allows for power supply and reception of signals from the sensors, and the output voltage changes depending on the detected surface, which allows it to be used not only with the Kitronik kit, but also with platforms such as Arduino or Raspberry Pi Pico. Kitronik 56111

Module with JST-ZH 1.5 mm connector dedicated to micro motors. Simple assembly, set of 2 pieces. Pimoroni PIM602

A small module with a GY-PAJ7620U2 gesture detection sensor. Can recognize 9 gestures. Communication via the I2C interface.

Serial Number iButton, F5 Size, RoHS, Maxim Integraded

A module for building a rear bicycle light using 1000 mCd red LEDs. Power supplied by AA batteries, which are not included in the kit. Kitronik 2106

Module with 4-digit 7-segment LED display. The board is equipped with a TM1637 driver and communicates via a digital interface

Piezoelectric vibration sensor with analog output, not loaded with mass, can be used as a vibration sensor. LDT0-028K/L

Infrared Thermopile Sensor in Chip-Scale Package, WCSP8, TI, RoHS

32bit ARM Cortex-M0, 32K Flash, 8K RAM, LQFP48, RoHS

Module with JST-ZH 1.5 mm connector dedicated to micro motors. Sideway assembly, set of 2 pieces. Pimoroni PIM603

A switching converter that regulates 9V from an input range of 2.6V to 20V. It offers high efficiency of 70-95% and the ability to operate with a continuous input current of up to 900mA and a peak current limit of 2.2A. With a switching frequency of 1.6MHz and a power-saving mode, it is suitable for both high-performance and low-power applications. Pololu 5584

The Sunon PF75302B1-1B00U-A99 is a 24 V DC blower fan designed for cooling systems that require directional airflow. Its low power draw, durable ball bearings, and flame-retardant housing make it ideal for industrial and electronic applications.

Module with a digital temperature and humidity sensor based on the SHTC3 system. Communication takes place via the I2C interface. DFRobot SEN0414

Module with three voltage analog outputs ranging from 0 to 10 V. It communicates via the RS485 interface and supports the Modbus RTU protocol. The board is enclosed in an industrial housing. Wellpro WP3079ADAM

STM8S 8-bit MCU, 32K Flash, 2K RAM, LQFP32, RoHS

7.9" LCD IPS display with touch screen. The display is equipped with HDMI interface for image display and USB for touch screen. High resolution 400x1280 pixels. Waveshare 7.9inch HDMI LCD

Module with 6-digit 7-segment LED display. The board is equipped with a TM1637 driver and communicates via a digital interface