Category: Main categories

Slim GPS Module Integrated with Patch Antenna, RoHS

USB 2.0 hub with 10 ports and 220 V / 3.5 A external power supply. The set includes a 1 meter cable. Supports USB 2.0 standard with speeds up to 480 MBit / s. You can also connect older generation USB devices. LogiLink UA0096

Extension board for Arduino Nano and Uno, 14 GPIO lines, connectors with I2C and UART interface lines. The board also has a RESET button and a voltage stabilizer

The current measurement with a value of 0 - 5A is realized by the ACS712-05 system based on the Hall effect. The system sensitivity is 185mV / A (analog signal).

The Intel FPGA Adapter (formerly J-Link Altera Adapter) connects to the Intel FPGA 10-pin JTAG connector, enabling debugging of FPGA-based MCU cores such as the dual-core Arm Cortex-A9 in Cyclone V devices. on Intel FPGA solutions.

LED RGB 5060 (PLCC6); 900mcd; 100 °;

This NEMA 17-size hybrid bipolar stepping motor has an integrated 28 cm (11″) threaded rod as its output shaft, turning it into a linear actuator capable of precision open-loop positioning. The stepper motor has a 1.8° step angle (200 steps/revolution) and each phase draws 1.7 A at 2.8 V, allowing for a holding torque of 3.7 kg-cm (51 oz-in). Pololu 2268

SimpleLink Wi-Fi CC3200 LaunchPad, TI, RoHS

Starter kit from NXP Semiconductors (formerly Freescale Semiconductor) based on the Kinetis K22F microcontroller with an Arm Cortex-M4 core, featuring a USB Type-C interface, integrated OpenSDAv2.1 programmer/debugger and an eCompass inertial sensor. FRDM-K22F

HDMI 4 Pi: 5" Display (no Touch) w/Mini Driver - 800x480 HDMI

Capacitive digital sensor for relative humidity and temperature, HLGA-6L, STM, RoHS

The Segger J-Link Signal Smoothing Adapter (8/06/12) is designed to improve signal integrity between the J-Link debug probe and the target debug device. It allows JTAG signals to be suppressed by adjustable series resistors, preventing excessive gain and jitter.

The Segger J-Link Measurement+Patch Adapter allows you to easily customize connections between J-Link or Flasher devices and boards that do not have a standard debug connector. It is equipped with colored wires for signal identification, test points and jumpers for adjusting the voltages on the pins.

Module with 1.3 "OLED display with a resolution of 128 x 64 pixels, thanks to the SH1106 driver and communication via the I2C bus is an ideal solution to build a device with a spectacular appearance and reliable work

Module with connector designed for 40-pin TFT displays. It allows for simple connection of the display and control using pin-outs with a convenient raster. Adafruit 1932

Robert Iannini