Category: Main categories

Electronic ball launcher in the form of a kit for self-assembly. The device is powered by two AA batteries

Voltage and current sensor module. It works with a shunt resistor and voltage divider and the INA-169 chip and can measure voltages up to 52 V and currents up to 90 A. SparkFun SEN-16408

Ultrasonic distance sensor with a measurement range of 50 cm to 1650 cm. It offers a resolution of 1 cm and has three outputs, including a voltage analogue output, an RS232 serial interface and a variable-width pulse output. SparkFun SEN-16463

Starter kit with micro:bit v2. The set includes the most necessary elements needed to implement micro:bit projects: LEDs, buttons, potentiometer, servo, prototype board and a set of cables. SparkFun KIT-17362

Waterproof servo with metal gearbox and aluminum housing. A standard PWM modeling signal is used for control. It offers torque up to 35 kg*cm. DFRobot SER0060

Case dedicated to protect GNSS receivers against difficult field conditions. Custom slots are molded into the case to hold the Facet RTK receiver, 915MHz radio with antenna, power supply, cables and adapters. SparkFun PRT-19642

Kit with Facet L-Band GNSS RTK receiver and accessories. Get centimeter-level global positioning measurements with GNSS RTK. SparkFun GPS-20000

Functional module for MicroMod boards. It allows you to add cellular communication to your project using the Notecard - NOTE-NBGL-500 from Blues Wireless. SparkFun WRL-20409

Set with Pixhawk 6C flight controller and PM02 power module and necessary accessories. It is ideal for developers in research labs, startups, academics and commercial applications. SparkFun ROB-20496

Set with Pixhawk 6C flight controller and PM02 power module and M8N GPS module. It is ideal for developers in research labs, startups, academics and commercial applications. SparkFun ROB-20497

Set with Pixhawk 6C flight controller and PM07 power module and necessary accessories. It is ideal for developers in research labs, startups, academics and commercial applications. SparkFun ROB-20498

Set with Pixhawk 6C flight controller and PM07 power module and M8N GPS module. It is ideal for developers in research labs, startups, academics and commercial applications. SparkFun ROB-20499

An expansion board designed for MicroMod main modules. It is equipped with a Qwiic connector and two sockets for attaching functional modules. SparkFun DEV-20595

An expansion board designed for MicroMod main modules. It is equipped with a Qwiic connector and one place for attaching function modules. SparkFun DEV-20748

An adapter dedicated to the FLIR Lepton thermal imaging camera. It has been preconfigured to operate as a USB plug-and-play UVC 1.0 camera, and can also communicate via UART and I2C interfaces. SparkFun DEV-20812

Color LEDs 4 mm, which is a solution between "ordinary" LEDs and fully addressable LEDs. The user cannot address every LED in the chain, but can change the color and mode of all LEDs in the chain. SparkFun COM-21209

MicroMod main module with STM32 microcontroller. Equipped with an M.2 connector, it can work with MicroMod expansion boards. SparkFun DEV-21326

5-port Hub with Grove connectors for M5Stack sets. It allows you to connect several devices with Grove connectors to the evaluation kit. M5Stack Grove-T

Cables dedicated to MyoWare 2.0 muscle tension sensors. It allows you to connect the electrode with the plate in the event that it must be located at a distance from the sensor. SparkFun KIT-19627

Pad dedicated to 3D printing. It has dimensions of 220x220 mm and is covered with a PEI coating on one side