PAM8410 2x15W stereo audio amplifier module

Module with an AB class amplifier based on the Boomer® LM4853 system. It can work in two modes: mono (power 1.5 W, load 4 Ω) or stereo (power 300 mW, load 8 Ω). It has a potentiometer for power control and gain control for the left and right channel. SparkFun DEV-14475

Class D mono audio amplifier module with MAX98357 chip. It can work with a 4 to 8 Ω loudspeaker with a power of up to 3 W and communicates via the I2S interface. modMAX98357

Microphone preamplifier based on the NE5532 chip. Powered with DC voltage from 9 V to 24 V or AC in the range from 8 V to 16 V

Audio amplifier module with three output channels. It can be powered with the voltage from 12 to 24 V and has two outputs with a power of 50 W (left and right) and one with a power of 100 W (bass)

Module with class D mono audio amplifier designed for QT Py and Xiao boards. It is based on the MAX98357 system and can work with a loudspeaker from 4 to 8 Ω with a power of up to 3 W. It communicates via the I2S interface. Adafruit 5770

WM8960 stereo codec module with driver for 1W class D speakers and headphones. It uses the I2S interface and the I2C bus to configure the system. SparkFun BOB-21772

Module of a stereo 24-bit audio converter with I2S interface (TS4657).

The board has a class D amplifier onboard that can drive 2 channels of 4-8 ohm impedance speakers at 20W each. Adafruit 1752

Audio preamplifier based on the NE5532 chip. Powered with symmetrical DC voltage in the range from 9 to 15 V

The TPA3116D2 amplifier module is a digital class D amplifier, offering 2x50W of power for stereo channels and 100W for the subwoofer, powered by 12V-24V. Thanks to the built-in NE5532 low-pass filter, it provides clean bass sound, and three potentiometers allow you to adjust the volume and cutoff frequency.

Audio amplifier based on the TPA3116 chip with a power of 100 W with an active low-pass filter. Dedicated to the bass column (subwoofer)

Module with the PAM8904 controller designed specifically to control piezoelectric elements. The amplifier operates over a wide frequency range, up to 300 kHz, and allows for gain up to approximately 13 Vpp. Adafruit 5791

Class-D mono audio amplifier module based on the MAX98357 chip. It can work with a 4 to 8 ohm speaker of up to 2.5 W and communicates via an I2S interface. DFRobot DFR0954

TPA3110 digital stereo audio amplifier module. The system allows you to connect two speakers with an impedance from 4 Ω to 8 Ω and a power of 15 W

Class D digital audio amplifier with Bluetooth 5.0 module. It has two channels with a power of 50 W and can work with speakers from 4 to 16 Ω. It is powered with the voltage ranging from 9 to 24 V.

Audio amplifier module with three output channels. It can be powered from 12 to 24 V and has two 50 W outputs (left and right) and one 100 W output (bass). Equipped with Bluetooth 5.0 communication