Mono Audio Amp Breakout - audio amplifier module with TPA2005D1
ID: 200864
5906623416776
zł41.91
Tax included
zł34.07 tax excl.
BOB-11044 OSHWTPA2005D1 class D audio amplifier module. The chip can work with a loudspeaker up to 1.4 W and 8 Ohm. SparkFun BOB-1104
Description
TPA2005D1 class D audio amplifier module. The system can work with a loudspeaker up to 1.4 W and 8 Ohm. The module has differential inputs that can be connected to ground referenced signals. The system has a switch-off input allowing for energy saving when the system is not in use and the possibility of connecting an additional potentiometer to adjust the volume.
A short instruction manual and an example module connection are available on the product's website.
Features
- Extremely efficient class-D amplifier
- 1.4W into 8 Ohms
- 2.5V to 5.5V supply
- Fully differential audio inputs, can be ground-referenced as well
- Shutdown input with pullup and LED-follows-shutdown circuitry
- PTH pads provided to change gain resistors if desired (see datasheet for details)
- Solder jumper and header allow addition of a 10k volume control potentiometer (not included)
200864
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
You might also like
10kΩ 10% multiturn mounting potentiometer THT, Vishay 500mW
zł2.90
24h
Available quantity: 1
Available
Module with a slide potentiometer. Depending on the position of the slider, the resistance value (maximum resistance 10kΩ) changes, which translates into the voltage value at the analog output of the module. The module has a connector in accordance with the Grove standard. Seeed studio 101020036
zł32.04
24h
Available quantity: 1
Available
Other products in the same category (16)
An audio module with a DAC converter and a stereo amplifier designed to work with the Raspberry Pi. Adafruit 3346
zł67.19
24h
Available quantity: 2
Available
Module with LM386 audio amplifier and loudspeaker. The board is equipped with a Grove connector and is controlled by a PWM signal. Seeed Studio 107020001
zł25.78
4 weeks
No product available!
Single-channel audio amplifier up to 100 W.
zł65.33
24h
Available quantity: 2
Available
Module with an AB class amplifier based on the Boomer® LM4853 system. It can work in two modes: mono (power 1.5 W, load 4 Ω) or stereo (power 300 mW, load 8 Ω). It has a potentiometer for power control and gain control for the left and right channel. SparkFun DEV-14475
zł95.58
24h
Available quantity: 2
Available
Pmod I2S2 is a module with 24-bit A / C and D / C audio converters derived from standard 3,5 mm Jack connectors. Thanks to them, it is possible to send and receive stereo audio signals using the I2S protocol. Digilent 410-379
zł128.35
24h
Available quantity: 10
Available
Module containing TSH82 operational amplifier from STMicroelectronics. The system has two built-in amplifiers and each of them is available separately on the pins of the board as inverting amplifiers. Sparkfun BOB-14874
zł43.32
24h
Available quantity: 2
Available
LM386 audio amplifier module. It is supplied with the voltage ranging from 4 to 12 V. The set includes an 8 Ω, 0.5 W loudspeaker. DFRobot DFR0064
zł61.97
24h
Available quantity: 1
Available
The Class D digital audio amplifier module has two channels with a power of 15 W and can work with speakers from 4 to 8 Ω. Powered with the voltage ranging from 8 to 26 V. Bluetooth communication
zł29.42
4 weeks
No product available!
The Class D digital audio amplifier module has two channels with a power of 30 W and can work with speakers from 4 to 8 Ω. Powered with the voltage ranging from 8 to 26 V. Bluetooth communication
zł29.67
4 weeks
No product available!
Stereo audio amplifier with a power of 40 W (2 x 20 W) powered with the voltage of 12 V. Equipped with an audio input in the form of two chinch sockets and an audio jack 3.5 mm input
zł57.76
24h
Available quantity: 8
Available
LM386 audio amplifier module in a set with a loudspeaker. The board is equipped with a Grove connector and is controlled by a PWM signal. Seeed Studio 101020853
zł57.54
4 weeks
No product available!
Class D mono audio amplifier module with MAX98357 chip. It can work with a 4 to 8 Ω loudspeaker with a power of up to 3 W and communicates via the I2S interface. modMAX98357
zł11.89
24h
Available quantity: 6
Available
Class D PAM8403 stereo digital audio amplifier module. The system allows you to connect two speakers from 4 to 8 Ω with a power of 3 W per channel. modPAM8403
zł2.36
24h
Available quantity: 4
Available
A sound card in the form of a small device with a USB plug, designed to work with the Raspberry Pi and NVIDIA Jetson Nano minicomputer. Waveshare USB TO AUDIO
zł32.69
4 weeks
No product available!
Sound card in the form of an expansion module with a USB adapter designed for NVIDIA Jetson Nano development kits. Waveshare Audio Card for Jetson Nano
zł79.08
24h
Available quantity: 2
Available
Audio module with DAC, headphone amplifier and display, designed to work with the Raspberry Pi. It is based on the PCM5100A system and communicates via the I2S interface. Pimoroni PIM482
zł158.14
24h
Available quantity: 1
Available
BOB-11044 OSHWTPA2005D1 class D audio amplifier module. The chip can work with a loudspeaker up to 1.4 W and 8 Ohm. SparkFun BOB-1104