VU meter - analog audio drive indicator 35mm

BOB-09868 - Breakout Board for ADMP401 MEMS Microphone, SparkFun

Crossover for tweeters with a crossover frequency of 3400 Hz. It works with speakers with an impedance of 4 to 8 Ω and offers power up to 60 W

Two-way loudspeaker crossover with a crossover frequency of 3200 Hz. It works with speakers with an impedance of 4 to 8 Ω and offers power up to 120 W

Audio module with DAC, headphone amplifier and display, designed to work with the Raspberry Pi. It is based on the PCM5100A system and communicates via the I2S interface. Pimoroni PIM482

The LM4950 audio power amplifier module with a power of 3 W per channel, powered by 10-15 VDC, equipped with a 3.5 mm Jack socket for audio input and screw connections for loudspeaker outputs, is equipped with thermal and short-circuit protection. It provides good sound quality with low energy consumption, making it ideal for small audio systems

The audio level indicator module with a JST PH 2.0mm connector is a versatile device that makes monitoring audio levels much easier while being easy to install and use.

The shield provides the standard MIDI port circuits, incl. 5-pin DIN connectors, pto-isolated MIDI input, LEDs on D6 and D7, pushbuttons on D2, D3 and D4, and rotary potentiometers on A0 and A1. DEV-12898

Class D PAM8406 stereo digital audio amplifier module. The system allows you to connect two speakers with an impedance of 4 to 8 Ω and a power of 5 W per channel

Speech recognition module with LD3320 chip, STC11 microcontroller, microphone and loudspeaker output. The board communicates via the UART interface

A set with an audio amplifier with a power of 350 W dedicated to the bass column (subwoofer)

Audio amplifier with three output channels. It can be powered with the voltage from 5 to 26 V and has two outputs with a power of 50 W (left and right) and one with a power of 100 W (bass). Equipped with Bluetooth 5.0 communication. XY-S100L

MEMS microphone module that will allow voice detection, sound recording or audio transmission. It communicates via an I2S interface. DFRobot SEN0526

The module with a digital stereo audio amplifier is equipped with Bluetooth communication. The system allows you to connect two speakers with an impedance from 4 Ω to 8 Ω and a power of 15 W per channel

This breakout board, the ultimate companion for the VLSI VS1053B DSP codec chip, can decode a wide variety of audio formats MP3, AAC, Ogg Vorbis, WMA, MIDI, FLAC, WAV (PCM and ADPCM); it can be used to record audio in both PCM (WAV) and compressed Ogg Vorbis. 8 GPIO pins can be used for lighting up small LEDs or reading buttons. Adafruit 1381

Module with an analog sound intensity sensor. It enables measurement in the range from 30 dB to 130 dB with a measurement error of ± 1.5 dB. The module returns the output voltage in the range of 0.6 to 2.6 V. DFRobot SEN0232

Class A power amplifier with one channel (mono) with the power of 10 W. Built on the popular design of J. Hood from 1969