![Main view Main view](https://kamami.pl/71215-large_default/two-way-speaker-crossover-3800hz-120w.jpg)
![Main view Main view](https://kamami.pl/71215-large_default/two-way-speaker-crossover-3800hz-120w.jpg)
zł9.70 tax excl.
Two-way speaker crossover with a division frequency of 3800 Hz. Works with 5 to 8 ohm speakers and offers up to 120 watts of power
free shipping in Poland for all orders over 500 PLN
If your payment will be credited to our account by 11:00
Each consumer can return the purchased goods within 14 days
Two-way speaker crossover with a division frequency of 3800 Hz. It allows splitting the audio signal into two bands, which can then be connected to a woofer (woofers) and tweeter (tweeters) with an impedance of 5 to 8 Ω. It offers up to 120 watts of power and can reproduce the entire audio band with high sound quality. It will find application in home and professional audio systems.
Audio amplifier based on the TPA3116 chip with a power of 100 W with an active low-pass filter. Dedicated to the bass column (subwoofer)
Audio amplifier with three output channels. It can be powered with the voltage from 5 to 26 V and has two outputs with a power of 50 W (left and right) and one with a power of 100 W (bass). Equipped with Bluetooth 5.0 communication. XY-S100L
No product available!
Audio amplifier module with three output channels. It can be powered with the voltage from 18 to 24 VAC and has two outputs with a power of 100 W (left and right) and one with a power of 120 W (bass)
A module with an electret microphone and amplifier that will allow you to detect voice, clap, slam doors and other sounds using an analog or digital output. SparkFun SEN-14262
No product available!
Audio preamplifier based on NE5532 chips. Equipped with an input selector function. Display and remote control included
Module with an analog sound intensity sensor. It enables measurement in the range from 30 dB to 130 dB with a measurement error of ± 1.5 dB. The module returns the output voltage in the range of 0.6 to 2.6 V. DFRobot SEN0232
No product available!
Class D digital audio amplifier with Bluetooth 5.0 module. It has two channels with a power of 50 W and can work with speakers from 4 to 8 Ω. It is powered with the voltage ranging from 9 to 24 V
Bluetooth 4.1 audio receiver with 3.5mm Jack audio output. It allows you to play files via Bluetooth, from a mass memory (flash drive) or from a microSD card. XY-BT
No product available!
A stereo tube preamplifier based on 6K4 tubes. Designed for use with active speakers or an additional amplifier and passive speakers. FX-AUDIO Tube-03
No product available!
A module with a MEMS microphone and an amplifier that will allow you to detect a voice, a clap or a door slam. The board has an analog output. SparkFun BOB-19389
Bluetooth 4.2 audio receiver with 5W stereo amplifier per channel. It allows you to play files via Bluetooth interface and supports WAV, APE, MP3 and FLAC formats. MH-M38
The module is based on the Si4703 FM tuner system. Supports wave reception in a wide frequency range from 76 to 108 MHz. It allows you to read RDS information. SparkFun BOB-11083
Module with a multi-channel WAV player. It allows you to mix 32 mono or 18 stereo tracks with the ability to connect to any MIDI controller. It has 8 mono or 4 stereo audio outputs. SparkFun WIG-18159
No product available!
This breakout board, the ultimate companion for the VLSI VS1053B DSP codec chip, can decode a wide variety of audio formats MP3, AAC, Ogg Vorbis, WMA, MIDI, FLAC, WAV (PCM and ADPCM); it can be used to record audio in both PCM (WAV) and compressed Ogg Vorbis. 8 GPIO pins can be used for lighting up small LEDs or reading buttons. Adafruit 1381
Module with VS1000D chip and SPI Flash memory, which allows you to play sounds in Ogg Vorbix and WAV format stored on a SPI Flash memory. SparkFun DEV-14006
BOB-11044 OSHWTPA2005D1 class D audio amplifier module. The chip can work with a loudspeaker up to 1.4 W and 8 Ohm. SparkFun BOB-1104
Stereo audio amplifier based on the TDA7498 chip. It can be powered with the voltage from 20 to 36 V and has two 100 W outputs
No product available!
Audio amplifier based on the TPA3255 system with a power of 600 W with an active filter. Dedicated to the bass column (subwoofer)
Class D digital audio amplifier. It has two channels with a power of 450 W and can be used with 8 Ω speakers. Powered by AC voltage 2x30V
Two-way speaker crossover with a division frequency of 3800 Hz. Works with 5 to 8 ohm speakers and offers up to 120 watts of power