Best sellers

Insulation for the 3D printer table. Helps maintain a constant table temperature during heating and increase print quality

MK8 complete hotend head kit for the Creality Ender and CR10 3D printer. It is equipped with a 0.4 mm print nozzle

Aluminum mounting profile for LED strips. It is W-shaped, black in color with a milky mask

Self-assembly enclosure included with the Odroid HC4 minicomputer. Equipped with a fan and two 3.5" SATA drive slots. Hardkernel HC4-P KIT

LED strip with addressable RGB WS2815 diodes on a black PCB. It is powered by 12 V DC, has a length of 1 m and 60 LEDs/m. Protection level IP67

Li-Po battery 3.7V / 980mAh, PCM protection, connector, 2 pins, cable length 150mm. Akyga LP573450

RYU002N05, MOSFET transistor, N channel, 0.9V, UMT3

8-wire cable, 10 cm long, with a JST SH-1.0 female plug at both ends

FDC6420C; MOSFET N / P transistor; SSOT-6, Fairchild / On Semiconductor

360° encoder module with LED indicators. It communicates via the I2C interface (Gravity connector). DFRobot SEN0502

4-wire cable, 10 cm long, with a JST SH-1.0 female plug at both ends

3-wire cable, 10 cm long, with a JST SH-1.0 female plug at both ends

Bluetooth module with integrated HC-08 system. Thanks to the angular pin connector with the bus signals, it is possible to easily connect the module to the contact plate or wires

Flexible LED (LED filament) in red, length 300 mm

The adapter allows you to connect the antenna with the SMA 50 Ω female connector to the device with the uFL socket (also known as u.FL, IPEX, IPAX, IPX, MHF, AM). The cord has a length of 20cm.

Module with MLX90614-DCC sensor for non-contact temperature measurement in the range from -70℃ to 380℃. I2C communication. DFRobot SEN0206

The adapter allows you to connect the antenna with the RP SMA 50 Ω female connector to the device with the uFL socket (also known as u.FL, IPEX, IPAX, IPX, MHF, AM). The cord has a length of 20cm

The X-NUCLEO-53L0A1 expansion board features the VL53L0X ranging and gesture detection sensor, based on ST’s FlightSense™, Time-of-Flight technology. It is an evaluation board that provides an introduction to the ranging and gesture detection capabilities of the VL53L0X module

Class-D stereo digital audio amplifier module PAM8403. The system allows you to connect two speakers with an impedance of 4 to 8 Ω and a power of 3 W. DFRobot DFR0119-O

Compact engine with 75: 1 LP transmission, shaft speed is 290 rpm, torque is 0.8 kg * cm (0.08 Nm), plate with connector PH 2.0. DFRobot FIT0457