Best sellers

Temperature and humidity sensor SHT20 closed in a waterproof housing. Communication via the I2C interface. DFRobot SEN0227

AO3406 MOSFET transistor module with N channel and JST PH2.0 connector designed to control motor, solenoid or LEDs. Adafruit 5648

Module with ToF VL53L4CD sensor with a range of up to 1.3 m and a resolution of 1 mm. It is equipped with a Qwiic connector and communicates via the I2C interface. SparkFun SEN-18993

Li-Po battery with a rated voltage of 3.7 V and a capacity of 300 mAh, equipped with a PCM protection and a 2.5 JST-RCY connector. Akyga LP752030

A set with a radio transmitter and receiver operating at 433 MHz. The modules are equipped with Gravity connectors and communicate via a digital interface. DFRobot TEL0140-1

Li-Po battery with a rated voltage of 3.7 V and a capacity of 620 mAh, equipped with a PCM protection and a 2.5 JST-RCY connector. Akyga LP852040

Lepton 3.5 thermal imaging camera module with PureThermal Mini Pro adapter. It allows you to connect the camera via the USB UVC interface, e.g. to a computer. SparkFun DEV-17544

Li-Po battery with a rated voltage of 3.7 V and a capacity of 250 mAh, equipped with a PCM protection and a 2.5 JST-RCY connector. Akyga LP601730

Module with SSR M281 relay with a load of up to 1 A. The board is equipped with a Grove connector and is controlled by a digital input. Seeed Studio 101020603

Active HDTV antenna with 28 dB amplification, supporting FullHD and 4K UltraHD standard. Designed for indoor installation. BLOW ATD40

Adapter for WS2811 LED strips designed for Teensy 3.2, 3.5, 3.6 and 4.1. It uses the 74HCT245 chip and RJ45 connectors for communication with RGB LED strips. Teensy 3.2-4.1 PJRC OCTO28-ADAPTOR

Module with a 3-axis KX132 accelerometer. The system has a user selectable measurement scale of ± 2/±4/±8/±16g. There are two Qwiic connectors on the board and holes with a 2.54 mm pitch. SparkFun SEN-17871

Rotating signal lamp powered with 12 V DC, yellow. LTE-1101

MEMS SPU0414HR5H-SB analog microphone module. The board is equipped with a Grove connector and communicates via an analog interface. Seeed Studio 101020852

SEN-12829

A short Pan / Tilt servo handle made of anodized aluminum. DFRobot FIT0039

PROLINE glue gun with a diameter of 11 mm and power of 200 W

Set of heat shrink tubing with tin and glue. Used for quick connection of wires

Doppler radar module with 24GHz BGT24LTR11 transceiver. The board is equipped with a Grove connector and communicates via the UART interface. Seeed Studio 109020021

Module with a current and voltage sensor dedicated to Feather boards. Can measure voltage up to 26 V and current up to 3.2 A. Based on INA219 sensor, I2C communication. Adafruit 3650