Best sellers
There are 16468 products.
Portable electronic component meter (LCR tester). Allows testing of common components used in electronics, including diodes, transistors, capacitors and resistors. Fnirsi LCR-T7
JST SH type connector, 1.0 mm pitch, surface mounted, horizontal spatial orientation. The set includes 10 connectors
Converter that provides easy communication between the RS485 and RJ45 Ethernet interface. Configurable via web page or AT commands. USR-DR302
FPC/FFC 12-pin adapter with 0.5mm pitch for DIP holes 2.54mm pitch.
JTAG interface galvanic separator that protects equipment against damage caused by potential differences, with a maximum clock frequency of 110 MHz, 3-5 V power supply, and isolation voltage up to 1 kVDC, equipped with multiple connectors and optical status signaling
Internal antenna Bluetooth, ZigBee, WLAN, chip SMD, 2.45GHz, gain 0.5dBi, dimension 3.2x1.6x0.9mm, Rainsun, RoHS
Prototyping circuit board designed for Wemos D1 Mini boards
A 150mm 3-wire cable terminated with a plug and socket JST SM3P.
The NEO TOOLS 13-858 construction marker with oil-based ink provides durable markings on various surfaces, including in outdoor conditions. Cost-effective solution for construction and industrial teams.
Breadboard Breakout for Analog Discovery is an adapter for use with Analog Discovery, it facilitates the use of the contact plate in conjunction with the Analog Discovery 2. Digilent 410-373
Female terminal block, 7-pin. Pitch 3.5mm. Height 7.8mm. Suitable for KF2EDGR male strips with a pitch of 3.5 mm. 2EDGKN-3.5
ARM Cortex-M0+ MCU, Low power, 64kB Flash, 8kB RAM, 2xUSART, 2xI2C, 2xSPI, ADC, STM, LQFP64, RoHS
Official 30W PoE+ injector that lets you power Raspberry Pi minicomputers over Ethernet with just one cable
SIM800L module with support for four-band GSM/GPRS network. Has a MicroSD card slot. Module controlled by AT commands.
LED 5 mm OVAL yellow, angle 130 degrees / 70 degrees; light intensity 900 mcd (20mA) (2.2V), df595 nm
A set of 10 green MF wires with a length of 18cm with insulated terminals
Charger module for Li-Ion batteries based on the TP4056 system. It can supply current up to 1 A. The input voltage of the module ranges from 4.5 to 8 V. It has a built-in Step Up converter
Universal tester of servos and ESC regulators. It allows you to check the operation of the servo without the need for a transmitter and receiver
ARK terminal connector spring 12-pin, pitch 3.81 mm, non-detachable
ARK terminal connector spring 7-pin, pitch 2.54 mm, non-detachable.