Best sellers

This gearmotor is a miniature high-power, 6 V brushed DC motor with long-life carbon brushes and a 297.92:1 metal gearbox. It has a cross section of 10 × 12 mm, and the D-shaped gearbox output shaft is 9 mm long and 3 mm in diameter. This version also has a 4.5 × 1 mm extended motor shaft.

A module with an electret microphone and an amplifier that will allow you to detect a voice, a clap or a door slam using the analog output

This gearmotor is a miniature high-power, 6 V brushed DC motor with long-life carbon brushes and a 100.37:1 metal gearbox. It has a cross section of 10 × 12 mm, and the D-shaped gearbox output shaft is 9 mm long and 3 mm in diameter. This version also has a 4.5 × 1 mm extended motor shaft.

COB LED ring, made of aluminum PCB, emits cold white light (6000-6500k) at 12 V DC with a maximum current consumption of 400 mA, offering a wide beam angle of 120 °

Module with a VOC sensor (volatile organic compounds) made in MEMS technology. It allows gas detection in the range of 5 to 500 ppm and has an analog output. DFRobot SEN0566

COB LED ring, made of aluminum PCB, emits cold white light (6000-6500k) at 12 V DC with a maximum current consumption of 500 mA, offering a wide beam angle of 120 °

40-pin cable dedicated to Raspberry Pi minicomputers. It has a male connector on one side and a female connector on the other

COB LED ring, made of aluminum PCB, emits cold white light (6000-6500k) at 12 V DC with a maximum current consumption of 350 mA, offering a wide beam angle of 120 °

DMos Dual Full Bridge Driver With PWM Current Controller and Decay select, PowerSO36, STM, RoHS

Permanent cylindrical neodymium magnet with a diameter of 15 mm and a height of 3 mm. Set of 5 pcs

Miniature high-power, 6 V brushed DC motor with long-life carbon brushes and a 29.86:1 metal gearbox. It has a cross section of 10 × 12 mm, and the D-shaped gearbox output shaft is 9 mm long and 3 mm in diameter. This version also has a 4.5 × 1 mm extended motor shaft. Pololu 3072

RC extension cable dedicated to servos, comes with JR/Futaba female and male connectors

Set of unshielded RJ-45 cat.6 network plugs. They are equipped with triple teeth, which allows them to be used with both wire and stranded cables. Additionally, each plug in the set has a guide to facilitate proper cable laying before connecting. Lanberg PLU-6000

Permanent cylindrical neodymium magnet with a diameter of 13 mm and a height of 3 mm. Set of 5 pcs

COB LED ring, made of aluminum PCB, emits cold white light (6000-6500k) at 12 V DC with a maximum current consumption of 1200 mA, offering a wide beam angle of 120 °

Module with 4-channel ADC ADS1115 converter. The system enables analog voltage conversion for single signals and differential signals with 16-bit resolution. I2C communication

Module with 4-channel ADC ADS1115 converter. The system enables analog voltage conversion for single signals and differential signals with 16-bit resolution. I2C communication

GPS module with u-blox ZED-F9R system. It uses Automotive Dead Reckoning (ADR) technology. It provides highly accurate and continuous positioning by combining the 3D IMU sensor, vehicle dynamics model, correction data and GNSS measurements. SparkFun GPS-22660

Classic joystick (control stick) with built-in 4 microswitches, which can detect 8 directions of movement in the XY plane. It is equipped with an ergonomic handle in the form of a pink ball, it will be perfect as a control element in typical arcade games

Classic joystick (control stick) with built-in 4 microswitches, which can detect 8 directions of movement in the XY plane. It is equipped with an ergonomic handle in the form of a blue ball, it will be perfect as a control element in typical arcade games