Best sellers
There are 16466 products.
Precision cutting pliers ideal for delicate electronics work, ensuring precise cutting of steel up to 2.5 mm thick. Piergiacomi PG-TR25
Needle bending needle, for precise glue application, Flux 0.84mm internal diameter and 1,26mm outside diameter. Set of 5 pcs
The high power motor driver module works on the basis of Infineon BTS7960B systems. Maximum controller current: 43 A, operating voltage range: 5.5V - 27V. The module has a heat sink and can be controlled from the Arduino, Raspberry Pi, and STM levels. IBT_2
Female terminal block, 12-pin. Pitch 3.5mm. Height 15.6mm. KF2EDGK
Plastic Surface Cleaner Foam 400ml - ART.008
A kit to extend the capabilities of the Fingerbot. Contains tips of different lengths and shapes to help adapt the module to different switches and buttons. Adaprox ADFT0101
Voltage divider module for measuring quantities in the 0V to 25V range.
MicroSD memory card reader module with SPI interface. Leads with a pitch of 2.54 mm allow you to place the module, e.g. in a breadboard
Lanberg Cat. 6A patch cord with Fluke Passed certification guarantees the highest quality and reliability, enabling optimal network connection compatible with various network devices in any environment. Lanberg PCF6A-10CU-0025-BK
Board with the ATmega4809 microcontroller from the AVR family and the u-blox W102 WiFi module. There are 14 I/O lines, 5 PWM channels, 6 analog inputs and the IMU LSM6DS3TR system at your disposal. Arduino ABX00021
8-wire cable, 10 cm long, with a micro 5264 female plug at both ends
Neodymium rectangular magnet with dimensions of 20x8mm a and a height of 2 mm. Set of 10 pcs
A 20 cm long 4-pin cable with a JST XH2.5 female plug on one side
The USB Step-Up 9V 6W converter module converts the input voltage in the range of 4.2-5.2V to a constant output voltage of 9V, with a maximum current of 1A and a conversion efficiency of 96%. The device can operate in a wide temperature range, from -40°C to 85°C, which makes it ideal for powering various electronic devices in harsh environments.
White LED (cold, 6000-6500K) with 1W power equipped with a heat sink. Brightness approx. 80lm, viewing angle 120 degrees.
Integrated gas sensor, pressure, humidity and temperature in the LGA-8 housing. Bosch Sensortec BME680
Eccentric spacer with an internal diameter of 5 mm. Allows adjustment of the roller pressure on V-Slot aluminium profiles in 3D printers or CNC machines.
A flexible cable type AA (tape) with a length of 20 cm. The tape has 20 wires and a pitch of 1 mm
Precision knife blade. Made of stainless steel, it ensures precise small cuts
Development kit with STM32L496ZGT6 microcontroller (ARM Cortex-M4 core) with a built-in ST-Link programmer. Extensive equipment, including: MEMS 6DoF sensor, motor controller, joystick, LED display, 8 LED diodes, RGB LED, audio amplifier, Flash memory QSPI 1 MB, microphone, Arduino connector