Best sellers

Male terminal block, angled, 2-pin. Pitch 3.81mm. Height 7mm. 15EDGRC. Set of 10 pieces

Water pressure sensor with 3-pin Gravity interface. It enables the measurement of liquid pressure in the range from 0 to 1.6 MPa. It is supplied with the voltage of 5 V and has a linear output voltage from 0.5 to 4.5 V. DFRobot SEN0257

Neodymium rectangular magnet with dimensions of 10x5mm a and a height of 2 mm. Set of 10 pcs

Neodymium rectangular magnet with dimensions of 9x9mm a and a height of 9 mm. Set of 5 pcs

Tic T500 USB is a stepper motor driver based on the MP6500 chip. It allows you to control the stepper motor whose voltage on the coil is 4.5-35V, the maximum current per coil is up to 1.5A. The controller can be controlled by: USB, TTL, I2C, RC (PWM model) etc. Pololu 3134

PIR motion sensor module for Arduino and Raspberry Pi. DFRobot SEN0018

Digital orientation sensor module. DFRobot DFR0028

Driver for EPAPIER displays in the form of a HAT overlay for Raspberry Pi computers. The SPI interface is used for communication with the controller. Waveshare e-Paper Driver HAT

Vorel cast iron vise for fixing to the table with a clamping screw. Maximum opening 50 mm. Vorel 36005

I2C BME680 Environmental Sensor is a gas, pressure, temperature and humidity sensor in one MEMS housing. The module is supplied with 3.3-5V, for communication the I2C or SPI interface is used. DFRobot SEN0248

Transparent case designed for micro:bit educational modules. Compatible with LEGO. DFRobot FIT0533

IoT DFRobot Gravity UART OBLOQ module for working with Microsoft Azure. DFRobot TEL0118

Range finder with a measuring range up to 12m. The current consumption is up to 120mA and the supply voltage 4.5 ... 6V. Communication via the UART interface. DFRobot SEN0259

Radio module with 868 MHz operating frequency. Communication takes place via the UART serial interface. It is supplied with the voltage in the range from 3.4 to 5.5 V. DFRobot TEL0115

LoRa MESH Radio Module is a radio module with an operating frequency of 868MHz. Communication with the module takes place via the UART serial interface. It has a range up to 3km. It is supplied with voltage in the range of 3.3-5V. DFRobot TEL0117

A versatile expander supported by the I2C interface, which significantly expands the capabilities of microcontrollers and microcomputers. It is based on the ATSAMD09 microcontroller and comes with default software that can be modified to suit the needs of the project. Adafruit 3657

7" LCD display with capacitive touch screen. The display is equipped with HDMI interface for image display and USB for touch screen. It has a resolution of 1024x600 pixels. DFRobot DFR0506

Plate for applications in the area of Internet of Things (IoT). The module was based on the ESP8266 system, which integrates WiFi, TCP / IP communication, 32-bit MCU, 10-bit ADC and many interfaces such as HSPI, UART, PWM, I2C and I2S. DFrobot DFR0489

The Breadboard Adapter is intended to be used with the Analog Discovery tool to provide a prototyping surface with a secure connection. It provides a female header to pass through all connections from the Analog Discovery 2 as well as a prototyping surface. The PCB provides two power rails directly routed from the V+ and V- pins on the Analog Discovery. Digilent 410-361

DEV-14459