Best sellers
There are 16516 products.
Red laser diode module with 5mW power, displaying intersecting lines. Ideally suited to the construction of the laser level, and thanks to the built-in driver, it is possible to power 3 - 5V. LD-G650A03 - Cross
No product available!
No product available!
A module that provides galvanically isolated, bidirectional I²C communication (SDA and SCL lines), protecting devices from incorrect connections and voltage differences. Thanks to the TI ISO1640B chip, it supports data transfer up to 1.7 MHz. Pololu 5390
No product available!
The module protects the load against reverse polarity to -60 V and blocks the flow of reverse current to the power supply. It uses the LM74700-Q1 ideal diode controller and a MOSFET transistor. Thanks to its low impedance (1.5 mΩ), it supports currents up to 25 A continuous and 50 A transient, providing reliable protection and the possibility of easy assembly. Pololu 5389
No product available!
Probe for measuring direct and alternating current up to 30 A. Works in the band up to 100 MHz, can be connected to the oscilloscope through the BNC connector. Powered by USB. Micsig CP1003B
No product available!
HAT module designed for Raspberry Pi minicomputer. Powala adds two CAN interfaces to the project. Waveshare 2-CH CAN HAT
No product available!
Probe for measuring direct and alternating current up to 30 A. Works in the band up to 50 MHz, can be connected to the oscilloscope through the BNC connector. Powered by USB. Micsig CP503B
No product available!
Lead-free Sn99.3Cu0.7 1.1.3 solder wire, manufactured in accordance with the EN ISO 9453:2014 standard, combines rosin, halide-free 1.1.3 flux with high-quality binder, meeting the requirements of the RoHS2 directive and guaranteeing performance in electronics and electrical engineering
No product available!
No product available!
Industrial input/output expansion board based on VNI8200XP and CLT01-38SQ7 for STM32 Nucleo
No product available!
No product available!
Crossover for woofers with a division frequency of 300 Hz. Works with 4 to 8 ohm speakers and offers up to 200 watts of power
No product available!
The Lanberg Cat. 8.1 patch cord with Fluke Passed certification guarantees top quality and reliability, enabling optimal network connections compatible with various networking devices in any environment. Lanberg PCF8-10CU-0100-G
No product available!
The L78L33ACU voltage regulator provides 3.3 V output at up to 100 mA with low quiescent current. It is intended for low-current electronic applications where voltage stabilization with input up to 30 V is required.
No product available!
The ring has sixteen RGB WS2812 diodes, controlled by means of serial signals. The module can be supplied with voltage from 4-7V, only one signal line is required to control it. NeoPixel Ring 16 x WS2812
No product available!
Shield for STM32 Nucleo that allows you to add the possibility of operating a three-phase brushless motor (BLDC) or synchronous permanent magnet (PMSM). It uses the L6230 chip for control. X-NUCLEO-IHM07M1
No product available!
No product available!
ATTINY44A-PU
ATtiny44A-PU is a microcontroller from the AVR family in the DIP14 housing, it is equipped with memory: 2 kB Flash, 128 B SRAM, 128 B EEPROM. The power supply voltage is 4.5..5.5 V, the maximum clock speed is 20 MHz.
No product available!
USB splitter allowing to connect up to 4 USB devices. It has a cable with a length of 80cm, a power indicator and the possibility of powering from an external source with a microUSB connector
No product available!
No product available!