Best sellers
There are 17364 products.
The GY-BMP280 is an atmospheric pressure sensor module. It allows measurement in the range of 300 ... 1100 hPa with an accuracy of 1 hPa. The sensor uses I2C or SPI bus
FT230XS-R, USB-UART (RS232/RS422/RS485) converter, SSOP-16
Internal antenna Bluetooth, ZigBee, WLAN, chip SMD, 2.45GHz, gain 0.5dBi, dimension 3.2x1.6x0.9mm, Rainsun, RoHS
StarCB-6ULL-STD v.1.1 is the base board for StarSOM-6ULL (i.MX6 ULL) modules. The board contains, among others Ethernet and USB connectors, connectors compatible with Raspberry Pi HATami, 5 buttons and 5 LEDs. SoMLabs StarCB-6ULL-STD v.1.1
Corner connector for V-shaped mounting profiles. In white
ARK terminal connector spring 12-pin, pitch 3.81 mm, non-detachable
Power cord with a length of 20 cm with SATA and XH2.54 plug. It allows you to power a hard drive with a SATA connector.
Board with USB-Type A connector (male) with USB lines connected to the goldpin connector (2.54mm)
Step-Down converter with adjustable output voltage from 1.25 to 36 V, input voltage from 4 to 38 V and maximum current up to 5 A
Miniature micro-SD card reader with USB 2.0 interface. The reader\'s casing is made of aluminum, black. Works with both Windows and Mac OS
A 2.4 GHz PCB antenna with an IPEX connector, featuring a 4 dBi gain and compact dimensions, designed for Wi-Fi, Bluetooth, and ZigBee modules. Thanks to its low loss and simple installation, it is used in IoT devices, wireless communication systems, and consumer electronics
The module with the HC-05 compatible transceiver makes it easy to add Bluetooth communication to an existing project. The system is controlled by exchanging AT commands (UART bus)
2p male straight plug for PCBs, 2.54mm, tinned, white. Set of 10 pieces
Under ambient conditions of 25℃, the ED-Pi4Case-OB case can reduce the temperature of the Raspberry Pi 4 by approximately 25℃ during stable operation. This enables the Raspberry Pi 4 processor to operate continuously at its maximum frequency of 1800 MHz.
LED 5 mm OVAL yellow, angle 130 degrees / 70 degrees; light intensity 900 mcd (20mA) (2.2V), df595 nm
Ceramic heater designed for installation in the heating block of a 3D printer. Power 40 W, powered by 12 V
Ceramic heater designed for installation in the heating block of a 3D printer. Power 40 W, powered by 24 V
Ceramic heater designed for installation in the heating block of a 3D printer. Power 50 W, powered by 12 V