Best sellers

A digital multimeter that is used to measure electrical quantities such as AC and DC voltage, AC and DC current, resistance, capacitance and frequency, and temperature. It has an LCD display and backlight, as well as functions for automatic range change, measurement stop and circuit continuity test. Aneng AN8009

Module with ATmega32u4 microcontroller and 900 MHz wireless transceiver. The module can be used for transmission in the ISM 868 MHz band after the appropriate software configuration. The microcontroller is clocked at 8 MHz and works at 3.3 V. Adafruit 3076

Two-way speaker crossover with a division frequency of 2500Hz/3000Hz. Works with 4 to 8 ohm speakers and offers up to 250 watts of power

The adapter allows the Teensy 3.x family to be similar to the Feather family tiles. Thanks to this, it is possible to use a wide range of extensions for Feather tiles. Adafruit 3200

A module with two PC817 optocouplers. Allows you to add galvanic separation in the form of opto-isolation between electrical circuits

DC motor with 1:48 plastic gearbox. equipped with incremental encoder with Hall sensors. Includes bracket, mounting hardware and cord

The charger is designed for 1S and 2S LiPo batteries. It is powered by a USB type C connector. ISDT UC2

Discovery kit based on STM32G431CB microcontroller, L6387 controller and STL180N6F7 MOSFET power transistors. Designed to drive a 3-phase brushless motor (BLDC/PMSM) and implement both sensorless FOC or 6-step algorithm. STMicroelectronics B-G431B-ESC1

Camera for Raspberry Pi minicomputers. Works with all versions of minicomputers with a CSI socket. The camera is equipped with a Sony IMX477R sensor with a resolution of 12.3MPx and a built-in IR filter. Raspberry Pi HQ Camera

Official camera module set to work with Raspberry Pi minicomputers. Equipped with a Sony IMX708 sensor with a resolution of 12 Mpx and a lens with a viewing angle of 75 ° with autofocus. Raspberry Pi SC0872

The Through Hole Resistor (THT) kit is suitable for electronics enthusiasts, hobbyists and professionals alike. It contains as many as 130 types of resistors, 20 pieces each, thanks to which you can gain access to the development of the resistance value algorithm, and then to the implementation of various projects

Module with a display designed to indicate the battery level. TM1651 controller, control via the I2C interface. DFRobot FIT0466

The HDMI adapter with a terminal block in a black housing facilitates prototyping, eliminating the need for soldering. Solid clamps and durable workmanship guarantee a secure and stable connection, and at the same time allow for quick and easy configuration modification

Step-Up DC-DC converter module. It has an input voltage of 1.3 to 16 V, an output voltage of 3.3 V and a maximum input of up to 2 A. Pololu 4940

Step-Up DC-DC converter module. It has an input voltage of 1.3 to 16 V, an output voltage of 5 V and a maximum input of up to 2 A. Pololu 4941

2-wire cable with JST plug, cable ends are tinned, length 15 cm, 2mm pitch. The cable has an additional 2-pole angled cable-to-board socket

The inverter is powered by 12V DC, it generates alternating current to supply electroluminescent wires that glow under the influence of high voltage supply

Support ball with mounting for Romi Chassis chassis. Pololu 3539

This set of six battery contacts completes the six AA battery holder molded into the Romi chassis base plate. Pololu 3540

A module with 4 PC817 optocouplers. Allows you to add galvanic separation in the form of opto-isolation between electrical circuits