Best sellers

Antistatic mate ESD 1000x600mm 2mm for service, green/grey

A universal oscilloscope probe with a BNC connector and a 10:1 voltage divider. It has a frequency response of 60 MHz and allows measurements with a maximum voltage of up to 600 V. Hantek PP-80

Small stand for TS100 or TS101 soldering iron in the form of a wire holder

S / FTP cable, Cat 6, 4 pairs of two wires, shielded with Al-PET, CCA, 4x2x27A WG, braided copper wire, gray. Goobay 95693

A sharp cone tip designed for the TS100 and TS101 soldering irons. Miniware TS-I

The portable power supply for electroluminescent wires is powered by two AA (R6) batteries, it has a built-in diode signaling the operating mode and a power supply output in the form of a wire terminated with a JST connector. The device also has a clip that allows you to hang them on trousers

A universal charger with four charging sockets designed for Li-Ion, LiPo, LiFe, LiHV, Pb and Ni-MH batteries. It has a built-in power supply with power of up to 200 W, which allows charging with a current of up to 5 A. ToolkitRC Q4AC

Compact charger dedicated to 2S-3S LiPo and LiHv packs with built-in balancer. Powered directly from AC mains, no additional power supply required. ToolkitRC C3

A universal oscilloscope probe with a BNC connector and a 10:1 voltage divider. It has a frequency response of 100 MHz and allows measurements with a maximum voltage of up to 600 V. Hantek PP-150

A 20:1 signal attenuator designed to assist in measuring automotive performance, including measuring fuel injector and primary ignition runs. Hantek HT201

The SST Liquid Level Sensor provides single point liquid detection via a TTL compatible push/pull output. This optical liquid level sensor features a miniature design that allows for installation in areas where space is limited. SEN-13835

An 8-channel digital oscilloscope that connects to a computer via USB interface. It has a frequency bandwidth of 100 kHz and is equipped with more than 80 types of functions for automotive diagnostics. Hantek 1008C

Digital oscilloscope with built-in signal generator. It has two measurement channels with 150 MHz bandwidth and a single-channel signal generator with waveform frequencies up to 25 MHz. Hantek DSO2D15

Digital oscilloscope with built-in signal generator. It has two measurement channels with 100 MHz bandwidth and a single-channel signal generator with waveform frequencies up to 25 MHz. Hantek DSO2D10

Digital oscilloscope. It has two measurement channels with 100 MHz bandwidth. Hantek DSO2C10

A two-channel DC motor controller with an I2C interface. It is powered from 4.5 V to 48 V and can deliver up to 1.8 A per motor. A board with connectors for mounting. Pololu 5065

1.3 "Monochrome OLED display with 128 x 64 pixels resolution with SH1106 driver The text is displayed in blue, thanks to OLED technology, the power consumption is only 0.08 W. Communication via the SPI interface

Camera module with Sony Starvis IMX290 sensor that works with Raspberry Pi minicomputers. It has a 2 MP sensor and an 80° viewing angle lens, and is equipped with a movable IR-CUT filter. ArduCAM B0424

YT-81656 is a white PVC electrical insulation tape compliant with the EN60454 standard, designed for insulating wires, bundles, and electrical connections. It offers high dielectric strength as well as protection against mechanical and environmental factors.