Best sellers

The charger module is designed for 3 Li-Ion cells. It is equipped with a micro USB and USB type C connector and supports fast charging (QC).

BMS protection circuit designed for 6 Li-Ion cells. It has a charging function with balancer option, a discharging function and an over-discharge protection function. HXYP-C47-MA18-6S

Nylon PA12 filament in Black with a diameter of 1.75 mm. 0,75 kg of filament is wound on a spool. Fiberlogy Nylon PA12 Black

ESD-17 curved tweezers 125 mm long. Antistatic, antimagnetic. Ideal for working on SMD electronics

Standard analog servo with plastic gear. It has a 180° range of motion and derived feedback output. Pololu 3442

Tilt Sensor

RC extension cable dedicated to servos, comes with JR/Futaba female and male connectors. It has twisted wires

Ceramic heater designed for installation in the heating block of a 3D printer. Power 50 W, powered by 12 V

Ceramic heater designed for installation in the heating block of a 3D printer. Power 40 W, powered by 24 V

Ceramic heater designed for installation in the heating block of a 3D printer. Power 40 W, powered by 12 V

A heatsink-style enclosure designed for Raspberry Pi Zero 2W minicomputers. The user has free access to all ports of the minicomputer, including the GPIO connector

Audio module with DAC and mono amplifier designed to work with TinyPICO and TinyS2. Pimoroni SHIELD-AUDIO-I2S

Heat shrink tubing with tin and glue. Used for quick connection of wires

Espressif ESP32-S3 WiFi and BLE module board. It offers 8 MB of flash memory and 8 MB of SRAM. It is equipped with a USB type C connector and a WiFi/BT antenna. Seeed Studio 113991114

Self-assembly enclosure included with the Odroid HC4 minicomputer. Equipped with a fan and two 3.5" SATA drive slots. Hardkernel HC4-P KIT

Digital panel meter with red and blue LED display. It allows you to measure DC voltage up to 100 V and current measurement up to 10 A. Equipped with 15 cm long cables

Nozzle designed for 3D printers with a Volcano hotend. It is much longer than standard V6 nozzles, which makes it possible to achieve higher print speeds. The Teflon coating prevents the filament from sticking to the nozzle

10 cm long cable with plug and XT60 socket. It allows you to connect a battery with an XT60 socket, e.g. to a charger

Nozzle designed for 3D printers with a Volcano hotend. It is much longer than standard V6 nozzles, which makes it possible to achieve higher print speeds. The Teflon coating prevents the filament from sticking to the nozzle