FTDI Friend + extras - v1.0 - USB-UART converter with FT232RL

Versatile USB protocol converter, offering four channels (RS485, RS232, two TTL) and 12V, 5V and 3.3V power supply, ideal for IoT and industrial applications. Compatible with Windows, Linux, LattePanda and Raspberry Pi, no drivers required, and optional installation allows easy device management. DFRobot TEL0185

USB adapter designed for XBee modules. It can be connected to a computer with a USB cable and used with the X-CTU software to configure the XBee. DFRobot DFR0174

RS232 - UART converter module based on the MAX3232 chip. There is a DB9 connector on the board and a 4-pin connector with a 2.54 mm pitch

UART debugger module designed specifically for Raspberry Pi 5. Allows easy connection to UART debug connector via SH1.0 3PIN cable, ensuring convenient and effective debugging. Waveshare Pi UART Debugger

Xbee USB adapter based on the FTDI chip. Intended for configuring Xbee modules. Thanks to the female goldpin connector, it can be used as an FTDI programmer for Arduino FIO / pro / mini / lilypad. DFRobot DFR0050

A small USB-UART TTL converter module based on the CH340 system with a USB type A connector. Designed for the ESP-01 and ESP-01S modules

USB - UART converter based on the PL2303TA chip. Compatible with voltages of 3.3 V and 5 V, it has been equipped with a miniUSB connector. Waveshare PL2303 USB UART Board (mini) V2

USB-UART converter based on the CH340N chip. It uses a USB type C connector and ensures stable and secure communication between the computer and devices using the UART interface

This is a basic breakout board for the FTDI FT232RL USB to serial IC. The pinout of this board matches the FTDI cable to work with official Arduino and cloned 5V Arduino boards. It can also be used for general serial applications. DEV-09716

Overlay module for Raspberry Pi with GSM, GPRS, GNSS and Bluetooth

KAmod RS232H-mini is a miniature RS232 to TTL converter, operating in the voltage range of 3-5.5 V, supporting all RS232 signals, with a male DB9 connector, 2.54 mm goldpin pins, based on the MAX3243/SP3243 system, offering ESD protection up to 15 kV and a signal conversion direction corresponding to a DTE/Host device

USB-UART converter for Odroid minicomputers. It is based on the CP2102N chip and is equipped with a USB type C connector

BOB-12731

The module allows you to send UART (TTL) bus signals to a computer via a USB port. The adapter operates based on the PL2303HX chip and is recognized in the computer as a virtual serial port

A module with a USB converter - GPIO/ADC/I2C based on the MCP2221A chip. It allows you to connect sensors, displays or PWM drivers to the computer via a 2.54 mm or Stemma QT/Qwiic connector. Adafruit 4471