2.13inch e-Paper HAT (C) - 2.13" e-Paper color display module for Raspberry Pi

Description

The e-Paper display module with a diagonal of 2.13" and a resolution of 212x104. The display is connected to a small plate with a 40-pin connector compatible with Raspberry Pi. The module has the ability to display in three colors: black, white and yellow. The display has a built-in controller, communication is done using the SPI interface, has partial refresh functions, displays of this type are characterized by high contrast of the displayed image and low power consumption The module has a built-in voltage translator, making it compatible with 3.3 V and 5 V.

The module has support in the form of examples of use for such sets as Raspberry Pi/Jetson Nano/Arduino/STM32. Full module documentation is available on the Wiki page.

Features

• Screen size: 2.13"
• Resolution: 212×104
• Display color: yellow, black, white
• Gray level: 2
• Interface: 3-wire SPI, 4-wire SPI
• Dot pitch: 0.229 × 0.228
• Full refresh time: 15 sec
• Refresh power: 26.4 mW
• Standby power: <0.017 mW
• Viewing angle:> 170 °
• No backlight, displays the last content for a long time, even after turning off the power
• Low energy consumption
• Raspberry Pi 40-pin GPIO connector
• Built-in voltage translator, compatible with MCU 3.3 V/5 V
• Operating voltage: 3.3 V/5 V
• Display size: 23.71 x 48.55 mm
• Contour dimension: 65 × 30.2 mm

Kit contains

• 2.13inch e-Paper HAT (C)
• RPi screws pack (2pcs)
• PH2.0 20cm 8Pin