Sunon A2-03 power cable

Red laser diode module with 5mW power, displaying intersecting lines. Ideally suited to the construction of the laser level, and thanks to the built-in driver, it is possible to power 3 - 5V. LD-G650A03 - Cross

The ring has sixteen RGB WS2812 diodes, controlled by means of serial signals. The module can be supplied with voltage from 4-7V, only one signal line is required to control it. NeoPixel Ring 16 x WS2812

Photovoltaic panel allows conversion of solar radiation into electrical energy. It has 1W power and 6V output voltage, and its design has dimensions of 125 x 63mm. The panel is flooded with resin, which protects it against dirt and mechanical damage. Solar Panel 1W

Photovoltaic panel allows conversion of solar radiation into electrical energy. It has 2W power and 6V output voltage, and its construction has dimensions of 136 x 110 mm. The panel is flooded with resin, which protects it against dirt and mechanical damage. Solar Panel 2W

A set of basic electronic components (such as resistors, diodes or capacitors) complete with a contact plate and connecting cables. It is ideal for beginner electronics who also know Arduino

Analog-to-digital converter (dedicated to temperature / pressure sensors) with a 16-bit resolution, having a built-in reference voltage; output frequency up to 2k samples per second. The system has a TSSOP16 housing. ADS1146IPW

Stereo A / C converter, dedicated for cordless phones and digital audio players. The signal-to-noise ratio of the transmitter is 92dBA. Sampling at 8-96 kHz is possible, the system uses the I2C bus for communication. 24VQFN housing

Shield for STM32 Nucleo that allows you to add the possibility of operating a three-phase brushless motor (BLDC) or synchronous permanent magnet (PMSM). It uses the L6230 chip for control. X-NUCLEO-IHM07M1

ATTINY44A-PU

ATtiny44A-PU is a microcontroller from the AVR family in the DIP14 housing, it is equipped with memory: 2 kB Flash, 128 B SRAM, 128 B EEPROM. The power supply voltage is 4.5..5.5 V, the maximum clock speed is 20 MHz.

The BLE 4.0 Bluetooth module with the CC2541 system has an integrated PCB antenna and an extensive AES security system. Thanks to the built-in system CC2541 from Texas Instruments, it is possible to create a project without the use of an additional microcontroller. modCC2541

The GPS module allows you to download the current coordinates of position and time, has a built-in GPS receiver FGPMMOPA6H. MOD-54

The module enables wireless communication using Bluetooth Low Energy technology version 4.1. It has a built-in AMS002 chip with UART interface. MOD 61

Temperature and relative humidity sensor, equipped with HIH6130-021-001 system with I2C interface. MOD 68

Adapter for MQ gas sensor with potentiometer for analog signal calibration. MOD 72

RTC real time clock plate enables precise timing, is equipped with PCF8563.MOD-74

Adapter enabling easy and quick connection of Modular DuoNect expansion modules with a ribbon cable with an IDC connector. MOD-83