Wireless relay module 12V + 433MHz remote control

Module with Flash memory W25Q64 with a capacity of 64 Mbit (8 MB). It communicates via the QSPI interface. Adafruit 5633

The 2-way waterproof twisted connector with a screw terminal is a universal, easy-to-install and weather-resistant element connecting two wires, ideal for difficult tasks such as garden lighting installation or outdoor electrical work

5 m long LED strip with 100 purple LEDs. It is powered with the voltage of 12 V through the DC connector 5.5 x 2.1 mm. DFRobot FIT0385-P

Audio player and recorder with built-in VS1003 codec, 3.5 mm jack audio output and a microphone

Waterproof connector with plug, gaskets and contacts included. It can work with a voltage of up to 300 V and a current of up to 12 A

2x16 display with LED backlight (yellow-green), 85x30 mm, (LCD-H-1602H-205 Y / G) NOTE !! PIN1 5V; PIN2 GND, extended temperature range "fast" h = 30mm

Slide switch; 2 position; It can switch voltage to 50 V and current to 0.5 A. SPDT. MSK-01

JST SH type connector, 1.0 mm pitch, surface mounted, vertical spatial orientation. The set includes 10 connectors

This module features a fixed-gain, 38 kHz modulated IR sensor and a corresponding IR LED with oscillator circuit to make a tiny proximity sensor. This low-brightness version draws an average of 8 mA at 5 V and has a typical sensing range up to approximately 12 inches (30 cm).

Module with an 8-channel ADC converter with 8-bit resolution. It uses the ADS7830 chip and is equipped with a STEMMA QT connector, thanks to which it communicates via the I2C interface. Adafruit 5836

Inverter powered by 100 - 240 V AC, generates alternating current to power electroluminescent wires glowing under the influence of high voltage

The trigger module is designed for chargers PD 2.0 and PD 3.0. It is equipped with a USB type C input and output on pads. Allows you to power devices with 5 V, 9 V, 12 V, 15 V and 20 V and test chargers by replacing the PD device

IPS 11.9" LCD display with touch panel dedicated for Raspberry Pi. It is equipped with DSI interface for image display and I2C interface for touch screen. Resolution 1480x320 pixels. Waveshare 11.9inch DSI LCD

USB - RS232/RS485 converter equipped with the original FT232RNL system. The housing is made of industrial ABS, making it a versatile tool for various industrial and commercial applications. Waveshare USB TO RS232/485 (B)

Power supply module with an input voltage from 6 to 12 V and a configurable output voltage of 3.3 V or 5 V. It has holes with a 2.54 mm pitch. Perfect for use with a breadboard. SparkFun PRT-13032