Main view
search
  • Main view
  • View from top
  • Angled view
  • Kit view
  • View from back
ID: 1208260
zł74.40
Tax included

zł60.49 tax excl.

W5500 Ethernet controller board with an SPI interface and RJ45 connector for adding wired network connectivity to microcontroller-based systems. The W5500 integrates a hardware TCP/IP stack, 10/100 Ethernet MAC, PHY, and 32KB packet buffer and supports up to 8 hardware sockets simultaneously. Suitable for IoT devices, automation systems, data loggers, and network-connected controllers. Soldered 333039

Delivery date unknown
Out-of-Stock

Description

The device Ethernet Controller W5500 Board by Soldered uses the WIZnet W5500 controller to provide wired Ethernet connectivity for microcontroller-based systems. The IC integrates a hardware TCP/IP stack, 10/100 Ethernet MAC, and PHY, reducing the processing required from the host microcontroller for network communication. The board can be used in IoT devices, automation systems, data loggers, network controllers, and other applications requiring a wired network connection.

The W5500 supports TCP, UDP, IPv4, ICMP, ARP, IGMP, and PPPoE protocols and provides 32KB of internal buffer memory for Ethernet packet processing. The controller supports up to 8 hardware sockets simultaneously, allowing several network connections to be handled within a single application.

Communication with the host microcontroller is handled through the SPI interface using the MISO, MOSI, SCLK, and SCSN signals. Additional pins include INTN for interrupts, RSTN for controller reset, and OE for controlling the interface output state. Wired Ethernet connectivity is provided through the onboard RJ45 connector.

Hardware jumpers JP2, JP3, and JP4 allow the PHY operating mode to be configured, including 10BASE-T or 100BASE-TX operation, half-duplex or full-duplex communication, and auto-negotiation. Board dimensions are 54 × 38mm, while the 3.2mm mounting holes are designed for M3 screws.

Features

  • Ethernet
    • Controller: WIZnet W5500
    • Hardware TCP/IP stack
    • Integrated 10/100 Ethernet MAC and PHY
    • Supported protocols: TCP, UDP, IPv4, ICMP, ARP, IGMP, PPPoE
    • Internal packet buffer: 32KB
    • Simultaneously supported hardware sockets: 8
    • Ethernet modes: 10BASE-T and 100BASE-TX
    • Half-duplex and full-duplex support
    • Auto-negotiation support
    • Network connector: RJ45
  • Microcontroller communication
    • Interface: SPI
    • SPI signals: MISO, MOSI, SCLK, SCSN
    • Interrupt output: INTN
    • Reset input: RSTN
    • Output Enable pin: OE
  • Configuration
    • JP1: PWR LED control
    • JP2: PMODE0 configuration
    • JP3: PMODE1 configuration
    • JP4: PMODE2 configuration
  • Mechanical parameters
    • Board dimensions: 54 × 38mm
    • Header pin hole diameter: 1.5mm
    • Mounting hole diameter: 3.2mm
    • Mounting holes designed for M3 screws
1208260

Other products in the same category (16)