Pin Breakout - Pin Expander for Raspberry Pi Pico

A set for building a digital LED clock designed to work with the Raspberry Pi Pico. It has a built-in precision RTC DS3231 chip, light sensor, buzzer and configuration buttons. Waveshare Pico-Clock-Green-EN

Audio module with speakers designed to work with the Raspberry Pi Pico. Waveshare Pico-Audio

Universal module dedicated to e-Paper displays. It is equipped with connectors compatible with the Raspberry Pi Pico. It allows you to connect a display through one of the two FPC sockets. SB Components 26241

Audio module with DAC and headphone amplifier designed to work with the Raspberry Pi Pico. It is based on the PCM5100A system and communicates via the I2S interface. Pimoroni PIM544

L76B based GNSS module that can work with GPS, BDS and QZSS systems. Communication via the UART interface. Waveshare Pico-GPS-L76B

The board with prototype holes is dedicated to the Raspberry Pi Pico. It offers an area of 6x20 holes and two areas of 8x20 holes with a pitch of 2.54 mm with marked pin labels. SB Components 21505

Module of a 4-channel driver of DC motors with RP2040 microcontroller. It allows the connection of encoders and is equipped with a QW/ST connector. Pimoroni PIM636

WiFi module with ESP8266 designed to work with the Raspberry Pi Pico. It communicates via the UART interface using AT commands. Waveshare Pico-ESP8266

Module with a 2-channel driver for DC motors L293D designed to work with the Raspberry Pi Pico. It can work with a voltage from 6 to 12 V and a current of up to 600 mA. SB Components 21468

A pin expander designed for Raspberry Pi Pico boards. It is equipped with a standard female connector and four sets of male strips 2x20 pins. SB Components 21352

Kit for controlling soil moisture of cultivated plants. Equipped with a Raspberry Pi Pico W-based controller and soil moisture sensors with wires. Pimoroni PIM627

A power supply module with a LiPo and Li-Ion battery charger dedicated to the Raspberry Pi Pico boards. It has a built-in button and over-discharge and overload protection. Pimoroni PIM557

Module with OLED display, 1.3" diagonal and 64x128 px resolution. Communication via SPI or I2C interface. Waveshare Pico-OLED-1.3

The base plate is dedicated to the RP2040 Stamp module. It allows you to easily prototype devices based on RP2040. Pimoroni SP012

Module with 4 relays and optoisolation. Equipped with RP2040 chip and ESP8266 WiFi module. Can communicate via RS485 bus. SB Components 24124

2-channel module with relays designed to work with the Raspberry Pi Pico. It can switch signals up to 120 V AC or 24 V DC and currents up to 2 A. SB Components 21376