MAKER-PI-PICO-NB - base board for Raspberry Pi Pico

Module with IPS LCD display, 1.3" diagonal and 240x240 px resolution. Communication via SPI interface. Waveshare Pico-LCD-1.3

The expansion board with the LoRa E22-900T22S module for the Raspberry Pi Pico. It supports the LoRaWAN protocol and enables communication in the 868 MHz frequency band. SB Components 21628

2-channel module with relays designed to work with the Raspberry Pi Pico. It can switch signals up to 120 V AC or 24 V DC and currents up to 2 A. SB Components 21376

Module with a three-dimensional LED matrix 4x4x4 (64 LED) dedicated to the Raspberry Pi Pico. It allows you to control each LED and obtain 3D lighting effects. SB Components 22656

Module of a 4-channel driver of DC motors with RP2040 microcontroller. It allows the connection of encoders and is equipped with a QW/ST connector. Pimoroni PIM636

Expansion module designed for Raspberry Pi Pico boards. Allows you to add CAN bus based communication to your project. Waveshare Pico-CAN-B

Module with a differential pressure sensor based on the MPXV5010DP system. It uses a 22-bit ADC and allows the measurement of the pressure difference between two inlets in the range of up to 10 kPa. Comes with a soldered Raspberry Pi Pico W board. SB Components 26173

Shield with two relays for Raspberry Pi Pico, provides control of devices up to 250 VAC/3 A or 30 VDC/3 A, equipped with LEDs indicating the status of the relays and opto-isolation, ideal for home automation and other DIY projects

A set of goldpin male connectors intended for Raspberry Pi Pico boards. The set includes two 20-pin strips and one 3-pin strip with a pitch of 2.54 mm. Soldered connectors enable easy connection of expansion modules and other accessories

Universal board equipped with a metalized hole grid with a pitch of 2.54 mm, enabling mounting using goldpin strips or directly on the surface, with markings facilitating the identification of signals

The Raspberry Pi Debug Probe is an affordable tool that combines a USB-UART debugger and converter. Includes the necessary hardware and wiring needed to quickly debug the Raspberry Pi Pico, RP2040 microcontrollers, and other ARM Cortex-based MCUs. Raspberry Pi SC0889

Module with an IPS LCD display with a diagonal of 7" and a resolution of 1024x600 pixels dedicated to Raspberry Pi Pico boards. It uses the DVI interface for communication. Waveshare PICO-DVI-7inch

2-channel converter for Raspberry Pi Pico that provides easy communication between UART TTL serial interface and RJ45 Ethernet. Waveshare Pico-ETH-CH9121

RGB LED matrix display with a resolution of 64x32 (2048 LED) for Raspberry Pi Pico. Equipped with RTC clock, light sensor, buzzer and IR receiver. Waveshare Pico-RGB-Matrix-P3-64x32

Module with a flexible e-Paper display with a diagonal of 2.9" and a resolution of 296x128 px. Communication via the SPI interface. Waveshare Pico-ePaper-2.9-D

A set with a 64 MP camera and an adapter enabling the transmission of the CSI signal via an HDMI cable. Designed for Raspberry Pi and Jetson Nano minicomputers. The adapter module is also equipped with an audio connector and allows you to connect a microphone and headphones. ArduCAM B0399B0091